3
Installation Guide
AT-AVA-EX70-2PS-KIT
The AT-AVA-EX70-2PS-KIT includes two mounting brackets and four mounting screws each,
which can be used to attach the units to any flat surface.
1. Position one of the mounting brackets,
as shown below, aligning the holes on
the side of the enclosure with one set of
holes on the mounting bracket.
2.
Use the enclosure screws to secure the
mounting bracket to the enclosure.
3. Repeat the above steps to attach
the second mounting bracket to the
opposite side of the unit.
Mounting Instructions
FW
AT-AVA-EX70-2PS-RX
POWER
LINK
Included screws
4.
Mount the unit using the oval-shaped holes, on each mounting bracket. If using a drywall
surface, a #6 drywall screw is recommended.
NOTE:
Mounting brackets can also be inverted
to mount the unit under a table or other flat
surface.
FW
AT-AVA-EX70-2PS-RX
POWER
LINK
1. Connect a source to the
HDMI IN
port on the transmitter.
2.
Connect a display to the
HDMI OUT
port on the receiver.
3.
Connect an category cable, from the
HDBaseT OUT
port on the transmitter, to the
HDBaseT IN
port on the receiver.
4.
Connect the included 5V power supplies into the transmitter and receiver.
5.
Connect power supply to an AC outlet.
Installation
