15
14
U S E R M A N U A L
P A N D O R A D X L 1 9 2 0 L / 1 9 3 0 L C A R S E R V I C E - S E C U R I T Y S Y S T E M
Automatics starts can be enabled again by dialing
789*
(all previous settings will remain intact)
Blocking/unblocking the engine
You can block car’s engine using any phone. The engine will remain blocked until phone command
“Disable engine blocking“ will be sent. This blocking cannot be disabled using a tag.
1. Call the system number. Wait for answer.
2. Dial
666*
to enable engine blocking or
999*
to disable engine blocking (after dialing
999*
, you
will need to enter the “Secret PIN-code“ that is located on the owner’s plastic card).
Request current coordinates
1. Call the system number. Wait for answer.
2. Dial
500*
.
3. The system will confirm: “Current coordinate sent via text message“ and will send text message
with coordinates and a web link to a map to your phone.
To end session, hang up the phone.
Request GSM account balance
1. Call the system number.Wait for answer.
2. Dial
100*
.
3. The system will confirm: “Balance information sent via text message“ and will send text message
with account balance information to your phone.
To end session, hang up the phone.
Tow truck mode
This mode is intended for car transportation with preservation of arming function. Tow truck mode
can be activated only when the system is armed, it will be deactivated automatically when disarming.
1. Call the system number. If the system is in PANIC mode, receive emergency call. Wait for answer.
2. Dial
15*
to enable Tow truck mode, the system will disable motion, shock and tilt sensors.
3. To disable this mode, disarm the system.
To end session, hang up the phone.
Similarly any other system command can be entered.
Changing core settings via phone
To enter settings programming mode:
1. Disarm the system
2. Call the system number. Wait for answer.
3. Switch ignition on for 1-3 seconds, then switch it off.
The system will enter settings programming mode.
Example of changing the owner’s system number:
1. Enter the setting menu via a phone according to the instruction above;
2. Dial DTMF command
1*
(phone number settings) and
1*
(owner’s system number);
3. Enter new owner’s number in the format
*XXXXXXXXXXX #
(the system recognizes “*“ as “+“);
4. To confirm, dial
1*
WARNING! DISABLING OF THE ENGINE BLOCKING THAT WAS ENABLED VIA A
PHONE 666* IS ALLOWED ONLY BY DIALING 999* AND ENTERING THE “SECRET
PIN-CODE“.
WARNING!
THERE ARE ONLY TWO WAYS TO CHANGE THE OWNER’S PHONE NUMBER:
1. VIA A PHONE, USING CORE SETTINGS MENU.
2. VIA A COMPUTER AND PANDORA ALARMSTUDIO SOFTWARE
