63
62
USER MANUAL
PANDORA DXL 1090L SERVICE-SECURITY SYSTEM
Deleting mobile device:
LED
indicator will light red after entering the level. Press
VALET
button and hold
it for more than 4 seconds, release the button. The system will confirm deleting with
the series of sound signals of the siren and the system will return to mobile device
registration mode (
LED
indicator will light green).
Saving changes:
To finish the registration of a mobile device,
VALET
button should be pressed once,
the series of red and green flashes of the status
LED
indicator will confirm the saving,
switch on the ignition to save the settings and exit the programming mode.
Level 19, 20, 21, 22, 25, 26 – Updating firmware of additional devices
Download the firmware from www.pandorainfo.com and install Pandora BT
application on your mobile device.
To update firmware of additional devices, enter the programming mode and press
VALET
button the number of times equals to the desired level number (see the
Programming levels table). Find your system in the mobile application, go to detected
devices and upload the previously downloaded firmware to the system.
Level 23, 24 Recording door sensors №1, №2 (DMS-100 BT)
Door sensors recording is performed one by one starting from the 23 level: A door
sensor №1 is recorded on the 23 level; a door sensor №2 is recorded on the 24 level. A
door sensor can be overwritten only on the level of its initial registration.
To record door sensors №1, №2, enter programming mode and press
VALET
button
23 times for the door sensor №1 or 24 times for the door sensor №2.
LED
indicator will
light green and the system will enter the recording of a door sensor mode. Insert the
battery into the sensor. The system will confirm recording with a short sound signal.
Saving changes:
To finish the recording of the Bluetooth radio relay, press
VALET
button once, the
series of red and green flashes of the status
LED
indicator will confirm the saving,
switch on the ignition to save the settings and exit the programming mode.
ADDITIONAL DEVICES
Blocking BTR-101 radio relay is optionally
available for Pandora DXL 1090L. Blocking
radio relay with built-in accelerometer
should be placed in the engine
compartment. Herewith zone of built-in
aerial 2,4 GHz should not be shielded. Provide a rigid fastening to the car body or to
the fixed wirings. It is forbidden to hide the module in wiring. To save energy, radio
relay power is connected to the ignition. Radio relay is normally closed and has a full
set of contacts. Blocking is carried out on unauthorized movement.
Programming of radio relay is performed on level 6 or 7.
• Select desired level of the programming menu 6, 7 to program radio relay №1,
№2 respectively.
• Connect wire 1 of radio relay to the grounding spot.
Apply power (12V) to the contacts 3 and 4 of radio relay. The siren/Beeper will
confirm recording of radio relay to the system’s memory with 1 beep. Shortly press
VALET
button to save settings.
After successful recording of radio relay switch off and insulate contact 3, connect
contact 4 to any wire, which has constant voltage of 12V when ignition is switched on.
2
5
1
4
3
NO
NC
COM
Programming
6
Aerial 2,4 GHz
+12V
A D D I T I O N A L I N F O R M A T I O N
WARINGNG! DO NOT PLACE RADIO RELAYS DIRECTLY ON ENGINE
Bluetooth tag
BT-760
Remote control
D-010
Remote control
D-077/078
Remote control
D-707
Remote control
R-387
Engine compartment
module RHM-03 BT
P R O G R A M M I N G T H E S Y S T E M
