![P&M Aviation QUIK Maintenance Manual Download Page 48](http://html2.mh-extra.com/html/pandm-aviation/quik/quik_maintenance-manual_3068914048.webp)
Quik & Quik GT450 Maintenance Manual
29
th
March 2007
Issue 1
Page 48 of 54
6.
Lay the front strut within easy reach when you are stood at the nose of the trike. Stoop
under the nose of the trike, facing rearwards, and if the wind is calm firmly clasp the
control bar and lift it. If the wind is above 5 mph or gusting, then get a helper(s) to assist.
Where a rigging gas strut is fitted, much of the weight of the wing will be almost
immediately taken from you; where not fitted you will have to lever the wing up into
position while supporting most of the 95 lb (43 kg) during part of the lift.
7.
When the pylon is fully up, while still being ready to support the wing weight if a rigging
gas strut is not fitted, locate the pylon using the over centre catch, but do not overcentre
lock it at this stage. Get a helper to hold the bar or strap it back using the rear seat
harness; if it is at all windy it is essential to have a helper at hand. Fit the front strut, first
attaching it at the top with a pin and safety ring and then at the bottom with two pins and
safety rings. Secure the Overcentre Lever in its latch.
8.
Release the parking brake and turn the trike so that one wing is facing the wind, never
allowing the into wind wing to get higher than horizontal. Lower the wing to the ground
and attach it to an aircraft tie down point from the outer end of the lower flying wires.
Apply the parking brake.
Do not attempt to lift the wing to its rigged position without a rigging
gas strut if you have back problems or if you are slight in stature.
With wind input, you could find yourself with up to 110 lb (49 kg) of
dead weight to carry. If you are unfit to carry this weight in a stooped
position it is essential that a gas strut be fitted, or that you get an
assistant to complete this task.
It is particularly important to check that the two
lower pins pass through both the lower and
upper sections of the front strut, and that the
top connection is pinned. Failure to do so
could result in structural failure.
WARNING
!
WARNING
!