P&M Aviation QUIK-GTR, Operator'S Manual

Page: 38 / 95

P&M QUIK-GTR Manual, ref. QUIK-GTR Man 1.0.doc
Page 38
``
11. Disconnect the rigging tool pulley from the keyhole tang and remove the rigging tool from the rear of the
keel. Ensure that the previously fitted ribs are pushed FULLY home. Engage the over-centre levers
and tension them, ensuring they lie flat against the bottom of the sail. Tip the wing carefully onto it’s
nose.
Rigging stage 11
12. Ensure both the inner and outer washout rods are fully home and not caught on any ribs. The inner rod
can be seen through the zip access panel and the outer rod through the Velcro panel in the
undersurface.
13. Ensure the STARS system is routed correctly as shown by the GA drawing.
The rigging tool must be removed before flight
and before attempting to start the engine.
If the rigging tool is not removed, the propeller
will strike it.
WARNING
!