19
Usar_Manual_Pandhora_P3_ENG_Rev.0_05/2020
8.4 Environmental Transport Conditions
Temperature
Min -10°C –max + 50°C
Humidity
Max 90% without condensation
Atmospheric pressure
700-1060 hPa
9 Disposal of Equipment (Italy)
Pursuant to art. 13 of Legislative Decree 25 July 2005, n. 151 "Implementation of Directives
2002/95/EC, 2002/96/EC and 2003/108/EC, relating to the reduction of the use of dangerous
substances in electrical and electronic equipment, as well as the disposal of waste".
In fact, the waste of electrical and electronic equipment must be subjected to a special treatment,
essential to avoid the dispersion of polluting substances contained within the equipment itself, to
protect the environment and human health. It is also possible to reuse/recycle part of the materials of
wasted electrical and electronic equipment, thus reducing the use of natural resources as well as the
quantity of waste to be disposed of.
The abusive disposal of the product by the user entails the application of the administrative sanctions
pursuant to Legislative Decree no. 152/2006 (articles 255 and 256).
The disposal of the equipment contained within the P3 devices must absolutely
comply with the specific regulations of the country in which they are used. Pandhora
is not responsible for use that does not comply with the specific regulations in force.
10 Battery charge
It is recommended to keep the battery charged to get maximum autonomy at any time and maximum
profit from the thruster, as the voltage is constantly high. Moreover, the battery life is prolonged
because lithium, in all its forms, does not have the memory effect, so you can recharge even when the
battery is partially discharged.
Do not leave the battery charger at 230 V for a long time after the end of its recharging cycle, green
LED on.
Follow the instructions below to recharge the battery:
• Switch the device on (by keeping the button “
” pressed for a long time)
• Remove the battery from the holder by turning the key and sliding the battery upwards
• Connect the charger plug to the 230V 50Hz power supply
• Remove the protective cap located on the side of the battery
• Connect the charger plug
• The led light on the side of the charger indicates its status:
o Red-red: charging;