Part Names and Functions
2
10BASE-T/100BASE-TX/1000BASE-T port
Console port
SD card slot
Front panel
SFP extension slot
SFP+ extension slot
Stacking port
Power module slots (POWER 1, POWER 2)
Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull out
from the power port.
SD card slot
Insert an SD card into this slot to change/save settings and firmware.
SFP extension slot (ports 1 - 24)
SFP modules can be implemented (ports 21 - 24 will be exclusively used with
twisted-pair ports).
10BASE-T/100BASE-TX/1000BASE-T port (ports 21 - 24)
Connect 10BASE-T/100BASE-TX/1000BASE-T terminals, hubs, repeaters, bridges,
and Ethernet Switches, etc.
Set the twisted-pair cable (CAT5e or above) lengths so that they will fall within
100 m or shorter.
SFP+ extension slot (ports 25 - 28)
An SFP or SFP+ module can be connected.
Stacking port (ports 29, 30)
Up to four units can be stacked by 40G direct attach cables.
Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage this
Ethernet Switch.
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
: 1 bit
Flow control
: None
Emulation mode
: VT100
Data length
: 8 bits
Parity control
: None
Transmission connector : RJ45
Fan module slot 1
Fan module slot 2
Power module slot 1
Power module slot 2
MAC Address label
Power cord hook block
Back panel
Serial number label
Ground terminal
Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
12
Power supply redundancy can be realized by using additional power modules.
Connect the supplied power cord, and connect it to the power outlet.
Fan module slots (FAN 1, FAN 2)
The fan modules are replaceable. Normal operating requires 2 fan modules.
