Settings
25
8.3 Welding preparation
Wire extends out from the end of the welding torch and may stick into the
eye, face or body, which can cause injury.
Do not perform wire inching operation or pull the torch switch with your eyes, face or body close to
the end of the welding torch. Wire may stick into your eye, face or body.
Applying high-speed wire inching with the torch cable bent may cause the
wire to run through the resin liner and the cable.
In case of using a torch cable with the resin liner, straighten the torch cable and reduce the feed amount (current) to
a half or less before performing the wire inching. Please replace any damaged liner or cable with a new one as use
of them may cause gas leak or insulation deterioration.
Attention
In case of using a welding wire with a small diameter (0.8 mm
2
or 0.9 mm
2
)
Use of a wire in small diameter may cause unstable wire feeding. In case of using such wires, please feed the wire at
low speed or contact Panasonic representatives.
Press the “INCHING” (8) button on the operation
panel to feed the wire manually. The wire is fed
forward while this button is pressed. And the lamp is
on while feeding the wire.
*
Inching is available when the welder is in standby state.
*
Current set value for the main welding is
used to determine the wire inching speed.
*
If this button is pressed when the “F.
ADJ” or “RECORD” (“FUNCTION” (12)”) is
selected, the “no” “Arc” are displayed on (2)
and (5) respectively to indicate that it is
not possible to feed wire.
8.4 Checking shield gas
Prior to checking, read the operating instructions of the applied gas regulator.
Make sure to read and understand safety precautions.
Check the shield gas if necessary.
（
1
）
Check and make sure that the Flow
adjustment knob is place in the “SHUT”
position.
（
2
）
Turn on the gas cylinder main valve.
（
3
）
Press the “GAS CHECK” (10) button.
（
4
）
Turn the flow adjustment knob gradually
in the “open” direction until the flow
rate becomes appropri-ate.
Gas cylinder
main valve
Flow adjustment knob
Summary of Contents for YD-350FD2
Page 9: ...Rated Specifications 6 2 4 Dimensions 机型 W H L YD 350FD2HGY 570 1060 1200 YD 500FD2HGY ...
Page 30: ...Operation 27 9 2 CRATER Operation Turn the torch switch on and off twice ...
Page 45: ...Circuit diagram 42 13Circuit diagram 13 1 Circuit diagram for YD 350FD2HGY ...
Page 46: ...Circuit diagram 43 13 2 Circuit diagram for YD 500FD2HGY ...
