Configuration
OMCTT5621E18
11
4. Configuration
4.1 TIG welding
Customers are required to prepare the items other than
marked as “This product” or “Accessory”.
The items marked with “*” are available as peripheral
equipment (optional items), with separate sales. (See
section “Peripheral equipment”).
For arc spot welding, configurations are the same as the
followings.
In case of arc spot welding, it is necessary to prepare
“Arc spot nozzle” separately.
When using the special water-cooling torch
When using the special air-cooling torch
No.
Item
Remarks
No.
Item
Remarks
1
Welding power source
This product
13
Supply water hose
2
Argon gas regulator
*
14
Return water hose
3
Argon gas
15
Flow-rate switch cable
4
Gas hose
Accessory
16
Cooling water unit and cooling water
*3
*
5
Grounding wire
17
Gas hose
*5
6
Fingertip joint
*4
Accessory
*1
In the case of arc spot welding, use the special arc spot
nozzle.
*2
Connect it to the output cable of the base metal if neces
-
sary.
*3
Do not put the cooling water system on top of the welding
power unit.
*4
Welding torch and fingertip joint
Make sure to use the Panasonic genuine products only.
Or the connection part may be burnt due to poor contact.
*5
The gas hose lead-out point of the air-cooling TIG welding
torch is different from that of the water-cooling TIG welding
torch.
7a
Water-cooling TIG welding torch
*1 *4
*
7b
Air-cooling TIG welding torch
*1 *4
*
8
Base metal
9
Remote controller
*
10
Base metal cable
*2
11
Input power cable
12
Distribution box
Note
About “Base metal cable”
To prevent overheat of the cable and provide with proper
welding, prepare a cable which is a welding cable or
cabtire cable (excluding the class-1 cabtire cable and vinyl
cabtire cable) of 38mm
2
or more
About “Water-cooling welding torch”
In case of using water cooled welding torch, make sure
to supply cooling water while using the torch.Failure to
follow the instruction can damage the torch.
1
2
3
4
5
6
7a
8
9
10
11
12
5
13
15
14
16
5
1
2
3
4
6
7b
8
9
10
11
12
5
5
17
