20
■
Indicators and buttons
A
INITIAL SET button (Initializing button)
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera.
Disconnect the Ethernet cable from the camera.
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to re-
lease the button after approximately 15 seconds. In about 2 minutes later, the camera will start
up and the settings including the network settings will be initialized. Retry if the camera does not
start up normally.
IMPORTANT:
When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
B
LINK indicator
C
ACT indicator
When data is being sent via the network camera
Blinks green (accessing)
When the camera is able to communicate with
Lights orange
the connected device
*This illustration represents WV-S3131L.
A
INITIAL SET button (Initializing button)
B
LINK indicator
C
ACT indicator
D
SD ERROR indicator
Summary of Contents for WV-S3511L
Page 31: ...31...
