20
■
Indicators and buttons
A
INITIAL SET button (Initializing / NTSC
⇔
PAL switch button)
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera.
When using a PoE hub, disconnect the Ethernet cable from the camera. When using an
external power supply, disconnect the 2P power cable (accessory) from the power supply
terminal (12V DC).
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds.
In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized.
Retry if the camera
does not start up normally.
IMPORTANT:
When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
When the INITIAL SET button is pressed (less than 1 second) to switch the output signal of the
MONITOR OUT terminal, the MONITOR OUT terminal can be switched for the NTSC monitor
⇔
PAL monitor.
B
LINK indicator
C
ACT indicator
When data is being sent via the network camera
Blinks green (accessing)
When the camera is able to communicate with
Lights orange
the connected device
H
AF button
I
TELE button
J
WIDE button
A
INITIAL SET button (Initializing / NTSC
⇔
PAL switch button)
C
ACT indicator
B
LINK indicator
E
SD ERROR/AF indicator
SD slot
D
SD MOUNT indicator
G
SD ON/OFF
button
F
SD memory card warning/error indicator
