8
Step 2
Make a slit in the center of the cable cap (accessory) with a
cutter.
Cable cap
(accessory)
Step 3
Pass the cables from the housing base through this
bracket, and mount the cable cap that has slit in Step 2 on
the cable access hole (front).
Secure the housing base to the ceiling mount bracket.
Attach the housing base to this bracket using the 4 screws*
supplied with the camera. The "REAR" mark of the housing
base shall be directed to the wire hook section.
* Refer to the Operating Instructions of the camera for the
screws and the wrenches to be used, which depends on
models.
For the case of the camera with M5 screws being used:
Use the screws supplied with the camera and a hexagonal
wrench "for M5".
Wire hook
section
Cable access
hole (front)
Step 1
Decide the mounting position and drill a hole through the
ceiling.
Procure 4 pieces of M10 screws and anchors to secure the
this bracket on the ceiling.
For screws and anchors to be used, make sure that enough
salt damage prevention is applied. The hole diameter shall
be decided in accordance with the screws and anchors to
be used.
A hole through the ceiling with a diameter of 30 mm
{ø1-3/16 inches} or less can be hidden with this bracket.
* The above measurement diagram shows the view when
standing on the floor and looking up at the ceiling.
80 mm
{3-5/32 inches}
180 mm
{7-3/32
inches}
[2] Attaching the mount bracket
The installation of the ceiling mount bracket is roughly divided into 2 methods.
Refer to the applicable description.
■
When laying cables through the cable access hole (front) (
☞
8 page)
■
When laying cables after drilling a hole through the ceiling (
☞
10 page)
■
When laying cables through the cable access hole (front)
Summary of Contents for WV-Q121BS
Page 15: ...15 ...
