![background image](http://html.mh-extra.com/html/panasonic/wv-cp500-series/wv-cp500-series_installation-manual_262064012.webp)
12
Precautions for installation
This camera is designed to be used
indoors. This camera is not operable out-
doors.
Do not operate this product beyond the
specified temperature, humidity or power
source ratings.
Use this product at temperatures within
–10 °C to +50 °C {14 °F to 122 °F}, and
humidity below 90 %.The input power source
is 12 V DC/24 V AC (WV-CP504) or 120 V AC
(WV-CP500).
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your partic-
ular environment.
• Make sure that the installation area is
strong enough to hold the camera, such
as a concrete ceiling.
• If a ceiling board such as plaster board
is too weak to support the total weight,
the area shall be sufficiently reinforced.
• Do not install this product in a humid or
dust-laden environment.
Otherwise, lifetime of the internal parts
may be shortened.
Avoid installing in the following locations.
• Locations where it may get wet from rain
or water splash
• Locations where a chemical agent is
used such as a swimming pool
• Locations subject to steam and oil smoke
such as a kitchen, Locations near flam-
mable gas or vapor
• Locations where radiation or x-ray emis
-
sions are produced
• Locations subject to strong magnetic
field or radio waves
• Locations where corrosive gas is pro
-
duced
• Locations where it may be damaged by
briny air such as seashores
• Locations where the temperature is not
within –10 °C to +50 °C {14 °F - 122 °F}.
• Locations subject to vibrations (This
product is not designed for on-vehicle
use.)
• Locations subject to condensation as the
result of severe changes in temperature
Avoid installing the camera in a place with
a high level of noise.
Installation near an air conditioner, an air
cleaner, a vending machine, or the like
causes noise.
Avoid connections during a lightning
storm.
Otherwise, an electric shock may be caused.
Be sure to remove this product if it is not
in use.
Keep the camera cable away from the
lighting cable.
Failure to observe this may cause noise.
Radio interference
When the camera is used near TV/radio
antenna, strong electric field or magnetic
field (near a motor or a transformer), images
may be distorted and noise sound may be
produced.
Mounting screws
• Screws are not supplied with this prod
-
uct.
• Prepare them according to the material
and strength of the area where the prod-
uct is to be installed.
• Do not use an impact driver. Use of an
impact driver may damage the screws.
• The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
Summary of Contents for WV-CP500 series
Page 31: ...31 ...