Panasonic Workio DP-C265, Operating Instructions Manual

Page: 17 / 102

17
Chapter 2 General Settings
40 - 59 44 Data Deletion of
HD Set the deletion security level of hard disk
data for every copy/print job.
z Every copy/print job data is automatically
deleted after each job is completed.
For higher security, select “ Medium ” or
“ High ”, however, the deletion time
increases with the increase in security
level, and may take longer to erase the
data.
Basic, Medium, High Basic
45 WINS Server 1 IP Set the IP Address of WINS Server 1. 3 digits x 4 0. 0. 0. 0.
46 WINS Server 2 IP Set the IP Address of WINS Server 2. 3 digits x 4 0. 0. 0. 0.
47 Scope ID Set the Net Bios Scope ID. Up to 223 characters
48 IP Filter Set whether the IP filter is to provide
security for network functions such as
printer or scanner. Off, On Off
49 IP Filter Mode Set whether the registered “ 50 IP Filter
Address ” is allowed or denied for network
functions.
Allow, Deny Allow
50 IP Filter Address Set the IP Filter Address.
Up to 4 addresses can be set.
z When setting only one IP filter address,
enter the same IP Address for both “
Start
Address ” and “ End Address ”.
3 digits x 4 0. 0. 0. 0.
51 Community Name
(1) Set the SNMP community name (1). Up to 15 characters public
52 Community Name
(2) Set the SNMP community name (2). Up to 15 characters public
54 SysContact Set the system management name. Up to 31 characters
55 SysName Set the system name. Up to 31 characters Panasonic
DP-XXXX
56 SysLocation Set the system installation location. Up to 31 characters
59 SMB Set whether to use the machine on the
Microsoft
®
Network (SMB).
Off, On Off
60 - 79 60 SMB Master
Browser Set whether to use the SMB Master
Browser. Off, On Off
No. 45 to 60
After setting any of these parameters, turn the
machine’s power switch Off, and then On again.
Key Operator Mode
No. Parameter Comments Selective Item Standard
Setting
Continued on the next page...