– 1 –
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
■
Front View
REMOTE
TIMER
OPERATE
FULL
HDD
SEQUENCE
SET
LOCK
ALARM
ALARM
RESET
ALARM
SUSPEND
MULTISCREEN
SELECT
SETUP
/ESC
GROUP
SELECT
SPOT
MULTISCREEN
SUMMER TIME
EL-ZOOM
COPY
REC PREVIEW
INDEX
REC
FWD
REV
ALARM SEARCH
DISPLAY
REC STOP
1
2
3
4
13
14
15
16
9
10
11
12
5
6
7
8
Digital Disk
Recorder
WJ-HD
FS
16
q
w
e
t y u !0
!1
r
i o
!3 !4 !5 !6
!7
!8
!9
@0
!2
@1
@3
@4
@5
@6
@2
@7
@8
@9
#0
#1
STOP
B
PLAY/ PAUSE
q
Operate Indicator (OPERATE)
This indicator is on when the power of the WJ-HD500
Digital Disk Recorder is turned on.
w
Timer Indicator (TIMER)
Lights to indicate when the TIMER is set to INT (internal
timer) in the setup menu.
e
Remote Indicator (REMOTE)
Lights to indicate when the Disk Recorder is controlled
by an outboard device via the Serial or 10/100BASE-T
port on the rear of the Disk Recorder.
r
Alarm Suspend Indicator (ALARM SUSPEND)
Lights to indicate that the alarm suspension mode is
selected.
t
Alarm Reset Button (ALARM RESET)
This button cancels an activated alarm.
Pressing this button will reset the alarm and return the
system to the condition before the alarm function was
activated.
y
Alarm Indicator (ALARM)
This indicator blinks to indicate that an alarm condition
exists.
It changes to a steady light when the alarm is reset auto-
matically.
To turn the indicator off, press the ALARM RESET but-
ton.
u
Sequence Button (SEQUENCE)
Runs the assigned sequence on the selected monitor
screen for the specified duration.
During the sequence, pressing this button will pause the
sequence that is being run on the monitor screen.
The LED indicates the status as follows.
On: Sequence is being run.
Blinking: Sequence is in pause mode.
i
Multiscreen Selection Button
(MULTISCREEN SELECT)
Selects the multiscreen pattern to be displayed on the
Multiscreen Monitor that is connected to the MULTI
SCREEN OUT on the rear of the Recorder.
Pressing this button will toggle the display on the moni-
tor screen as shown below.
4
→
7
→
9
→
10
→
13
→
16
→
4 screen segments
o
Monitor Selection Button
(SPOT / MULTISCREEN)
Selects to control the display on the screen for either the
Spot or Multiscreen Monitor.
Pressing this button will toggle the indicator in the button
on and off to indicate the selected monitor as shown
below.
On: Indicates the Spot monitor is selected.
Off: Indicates the Multiscreen monitor is selected.
!0
Lock Button (LOCK)
Toggles to enable or disable the button lock function on
both front panels of the Disk Recorder and Remote
Controller.
The LED indicates the status as shown below.
On: The button lock is enabled.
Off: The button lock is disabled.
While On, the button lock will be released only if the pre-
set password is entered in the password inquiry window.