background image

5

Precautions

• Do not operate the appliance beyond its specified tem-

perature, humidity or power source ratings. 
Do not use the appliance in an extreme environment
where a high temperature or high humidity exists. Use
the appliance at temperatures 5 °C to +45 °C
(41 °F to 113 °F) and humidity below 85 %.
The input power source for this appliance is 220 V AC –
240 V AC 50 Hz. 

• Avoid shock and vibration

Shock or vibration may damage the HDD.
The HDDs are fragile especially when the HDD motors
are revolving and the HDD POWER indicator lights. Be
sure to turn off either switch: the POWER switch on the
rear panel, or the HDD POWER switch inside the front
lid: before you mount the unit into a rack or dismount it. 
Do not move the HDD for 30 seconds after turning off
the power.

• Pay attention to static electricity

Put your hand on a metallic surface to discharge static
electricity before installation.
Do not touch components mounted on the HDD directly
with your hand.
Hold only the two sides of the HDD when installing.

General

The extension unit WJ-HDE300 can accommodate up to four hard disk drives per unit to add available disk space to the digital
disk recorder WJ-HD316A/WJ-HD309A series. Up to seven extension units can be connected to a digital disk recorder. The
units can be operated in RAID level 5* mode for high tolerance to disk error.

* RAID level 5 (Redundant Arrays for Independent Disks, independent data disks with distributed parity blocks)

RAID level 5 regards 3 or more drives as one drive, and it is possible to read data by automatically attaching error correc-
tion data even though one of the drives is broken. (It is impossible to read data if 2 or more drives are broken.)
RAID level 5 requires a minimum of 3 drives per unit.
When using the RAID function, the logical disk size of the extension unit will be as below.
Logical disk size = Smallest size of the disk among the disks in the extension unit x (Number of the disks in the extension
unit - 1)  The actual space may be several percent lower than the logical space.
Even when the total capacity of HDD mounted on each extension unit is more than 2 TB, the capacity that is actually avail-
able will be 2 TB or less. 

* Important

When set to RAID level 5, the digital disk recorder will not access the HDD preinstalled in it, but will access only the HDDs
in the extension unit.

• Avoid condensation on the surface of the HDD. 

If this happens, do not turn on the power of the appli-
ance and leave the appliance for around 2 hours.
Wait until the dew evaporates in any of the following
cases.

• The appliance is moved to a place significantly dif-

ferent in temperature or humidity.

• The appliance is moved out from an air-conditioned

room.

• The appliance is placed in an extremely humid

place.

• The appliance is placed in a room where a heater

has just been turned on.

• Consumable parts

Contact your dealer about replacement when the time
comes. 
A hard disk drive needs replacing after a certain length
(depends on the model) of operation.
Cooling fans also need replacing after around 
20 000 - 30 000 hours of operation.

• Do not block the ventilation opening or slots on the

cover.
To prevent the appliance from overheating, place it at
least 5 cm (2 inches) away from the wall. 

• Avoid placing the unit on an inclined surface.

Otherwise, malfunction or damage to the disk may
occur. Place the unit in a horizontal position.

Summary of Contents for WJ-HDE300/G







Reviews: