Panasonic VW-PT2, Operating Instructions Manual

Page: 9 / 26

9
VQT1B03
battery cover back in its original place
after removing the battery.
∫
About the remaining battery
power
If the status indicator blinks at intervals of
about 1 second (blinks for about 0.5
seconds then goes off for about 0.5
seconds) when using the battery, the
remaining battery power has become low.
In this case, connect the AC adaptor or
charge the battery. If the battery is
completely discharged during copying, the
copying stops and the power automatically
turns off. You may not be able to playback
data that stopped being copied halfway.
Charge the battery sufficiently before
using the unit.
≥
Refer to page 19 for information about
the battery operation time.
∫
Connecting to the AC outlet
If you turn on this unit while charging the
battery using the AC adaptor, you can use
the power supplied from the AC outlet to
power the unit for use. (While it is in use,
the battery will not be charged.)
≥
You can also use this unit with the AC
adaptor only. However, we recommend
using the unit with the battery also
inserted when charging etc. to prevent
the power supply stopping.
¬
Inserting/Removing an
SD card
≥
Before inserting/removing an SD
card, be sure to turn the power [OFF].
1
Set the power switch to [OFF].
≥
Check that the status indicator A
has gone out.
2
Open the card slot cover.
3
Insert/remove the SD card into/from
the card slot.
≥
When inserting an SD card, face the
label side
B towards you and press
it straight in with one stroke as far as
it goes.
≥
When removing the SD card, open
the card slot cover and press the
center
of the SD card and then pull it
straight out.
4
Securely close the card slot cover.
If the SD card is inserted or removed with
the power turned on, this unit may
malfunction or the data recorded on the
SD card may be lost.
OFF ON ON OFF
OFF ON
A A
B
VQT1B03_Eng.book 9 ページ ２００６年１１月１０日 金曜日 午後６時１１分