Doorphone
15
Answering a call
When you receive a call from a door station, the sub monitor station rings and the TALK indicator
fl
ashes. You can
monitor the visitor on the monitor display before answering a call.
1
When a ringer tone is heard, press
{
TALK
}
.
2
Speak to the visitor.
L
Speak alternately with the visitor.
(If you and the visitor speak at the same time,
you will not hear each other.)
N
To adjust the speaker volume:
Press
{
▲
}
or
{
▲
}
.
N
To adjust the display brightness:
Press
{
BRIGHT
}
(page 8).
3
To end the conversation, press
{
OFF
}
.
Note:
L
If you do not answer a door call within 30 seconds, the display will turn off. A conversation will be automatically
disconnected in about 90 seconds and then the display will turn off. To turn on the display and talk to the visitor
again, press
{
TALK
}
.
L
The image taken by the door station is automatically recorded. Even if you do not answer a call, the image is
recorded (page 21).
L
You can record an image manually while monitoring the display during a call (page 21).
L
You can change the ringer tone by using the main monitor station (see the Operating Instructions included with
the main monitor station).
L
At night or when there is not enough lighting in the doorway, the display will be shown in black and white.
When using an additional door station or camera:
L
When you receive another call from an additional door station or an additional camera while receiving a previous
call, the display is switched to the image from the device calling later.
L
When you receive another call from an additional door station or an additional camera during conversation, see
page 18.
Answering a call by voice sensor (Voice answer mode)
This mode allows you to answer a call by voice without pressing
{
TALK
}
. Voice answer must be set “
ON
”
beforehand (page 26).
1
When a ringer tone is heard, answer with a clear voice such as “
Yes?
” or “
Hello?
”
(The visitor cannot hear your initial reply when you answer with voice.)
L
When a beep sounds, you can talk to the visitor.
Note:
L
Make sure you are within about 50 cm of the sub monitor station.
L
Your initial reply should be brief (less than 1 second), otherwise the voice answer mode will not start.
L
If a visitor calls you, a loud, brief sound (such as a barking dog) may start the voice answer mode even though
you have not replied by voice.
L
When you locate the sub monitor station near the main monitor station, the voice answer mode may be started by
a ringer tone.
L
The voice answer mode is also available for paging calls.
{
OFF
}
{
TALK
}
TALK indicator
{
BRIGHT
}
{
▲
}
{
▲
}
VL-W600BX̲ZA̲maybe̲E.indd 15
VL-W600BX̲ZA̲maybe̲E.indd 15
2009/04/01 17:52:38
2009/04/01 17:52:38
Summary of Contents for VL-W600BX
Page 31: ...31 Notes ...