38
Problem
Actions
Sound
Problem
Actions
No sound is produced
Other
Sound level is low
or sound is distorted
Unable to receive
signals with a
high-performance
aerial
Sound is unusual
TV unit goes into
"Standby mode"
An error message
appears
DVB
HDMI
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in some
cases, despite good reception of analogue programmes.
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu. (p. 16)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 34)
•
Sound signal reception may be deteriorated.
•
Set "MPX" (p. 16) in the Sound menu to "Mono". (Analogue only)
•
The sleep function is activated.
•
The TV unit enters "Standby mode" about 30 min.
after broadcasting ends.
•
Follow the message's instructions.
•
If the problem persists, contact the authorized
Service Centre.
An error message
appears
•
Contact the authorized Service Centre.
FAQs
•
Install an aerial individually for the TV unit and VCR
(or use a splitter).
TV
VCR
(Individual aerial)
(Individual aerial)
Aerial
Input
terminal
Splitter
Aerial Output
Aerial Input
Aerial Output
"Control with HDMI"
function does not work
•
Switch the TV unit on again with the equipment on.
•
Set “Control with HDMI” to “Off”, then set to “On” again. (p. 27)
Screen
Chaotic image, noisy
No image can be
displayed
Blurry or
distorted image
(no sound or low volume)
Neither image nor
sound is produced
•
Set "P-NR" in the Picture menu (to remove noise). (p. 16)
•
Check nearby electrical products (car, motorcycle,
fl uorescent lamp).
•
Is "Colour" or "Contrast" in the Picture menu set to the
minimum? (p. 16)
•
Reset channels. (pp. 20 and 24)
•
Some programmes may not be received when both Aerial and
CATV signals are connected to the TV through a mixer. In this
case, connect either Aerial or CATV signal directly to the TV.
•
Is the unit in "AV mode"?
•
Is the mains lead plugged into the socket outlet?
•
Is the TV unit turned On?
•
Check Picture menu (p. 16) and volume.
