Panasonic Viera TX-26LXD65F, Operating Instructions Manual

Page: 25 / 40

Advanced
IDTV
EXIT MENU
OK
M a i n m e n u
P i c t u r e m e n u
S o u n d m e n u
S e t u p m e n u
Child Lock
Profile Edit
Tuner Lock
DVB Setup Menu
System Update
Teletext
Subtitles
Tuning Menu
Off
ger
ger
Multi Audio ger
Access
System Setup
MENU
25
•
Common interface module (DVB)
•
Editing and Setting Channels (DVB)
Common Interface Module
The Common Interface Module menu provides access to software contained on Common Interface (CI) Modules.
These can be inserted in the “CI” slot located at the rear of the TV.
IMPORTANT NOTES:
• This TV receiver works only Pay TV modules complying with CI standard.
• Switch off the TV using the control panel switch before inserting or removing a module.
• If you are installing a TV software update, please follow the dedicated instructions supplied
with the module.
• Insert / remove a module straightly to the CI slot.
Insert the CI module:
Some Common Interface Modules may be a two piece design consisting of a
card reader together with the viewing card. When using this design of card,
fi rst insert the card reader fi rmly into the CI slot on the TV.
Secondly, insert the viewing card into the reader.
If no module is inserted the message “No module inserted” will be displayed. (If you have inserted a module, check
that it is fully inserted.)
The features that now appear on screen are dependent on the contents of the selected Common Interface Module.
Refer to the instructions supplied with the card or contact the vendor.
In all cases, it is possible to navigate the pages using buttons on the remote control, but because the commands
available must apply to all manufacturers of DVB equipment, some on screen commands may not correspond
exactly to the remote control buttons.
For example:
For the on screen command ‘
select ’ or ‘ go ’, use the OK button.
OK
Switch on the TV.
Auto
3 seconds
Common Interface Module
Time Zone
DVB System Setup
Access
Display Timeout
Preferred Language Setting
Slot 1: No module inserted
Common Interface Module
Access
3
1
2
Display the menu
Select "Setup menu"
Select
"DVB Setup Menu"
next
select
next
select
Select "System Setup"
4
next
select
5
set
select
Ŷ
To exit
EXIT
Select the “Common Interface Module” and set
(DVB mode)