48
Channel Allocation (Analogue TV mode)
Technical Information
Audio Signal
STEREO
MAIN
SUB
MONO
Mode Indicator
NICAM
.......Used in New Zealand, Singapore, Hong Kong etc.
Type of
broadcast
Regular broadcast
(Standard Audio)
R NICAM MONO
(MAIN )
NICAM
STEREO
NICAM DUAL MONO
(MAIN / SUB )
Mode Indicator
No
Indicator
A2 (German)
.......Used in Australia, Malaysia etc.
Type of
broadcast
Regular broadcast
(Standard Audio)
BILINGUAL or DUAL MONO:
MAIN / SUB
STEREO
Mode Indicator
No
Indicator
If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:MONO automatic
switching occurs, it is recommended you switch from STEREO to MONO.
Even when the contents of the receiving signal undergo changes, selection mode is kept intact.
When the receiving conditions deteriorate, listening will be easier if the mode is set to the MONO
position, using the stereo / bilingual sound selection button.
DUAL, also known as DUAL MONO or as BILINGUAL is not currently transmitted in some countries.
When you receive the stereo / bilingual sound system, sound output modes can be selected by
pressing the
Stereo / Bilingual Sound Selection
button.
Stereo / Bilingual Sound Selection (Analogue TV mode)
CH Display / Receive Channel
CH 0 - CH 5
S 2 - S 10
CH 5A
CH 6 - CH 9
CH 9A
CH 10 - CH 12
S 11 - S 44
CH 20 - CH 75
Rating (Digital TV mode)
Rating
Meaning
Rating
Meaning
-
Not classified
M
Mature
P
Pre school
MA 15+
Mature Adult 15+
C
Children
AV 15+
Adult strong Violence 15+
G
General
R
Restricted 18+
PG
Parental Guidance recommended
Updating the software system (Digital TV mode)
Update system software to ensure that you have latest version software.
If there is an update available, a notification banner is displayed when the channel has the update
information.
To download new software, press “OK” Downloading (approx. 1 hour)
If you choose not to download, press “EXIT”.
To update automatically
Set “Auto Update Search in Standby” to “On” (p. 27)
If there is a new version software being broadcast, the TV will download this automatically.
The automatic updating sequence is carried out at 3:00 AM and 5:00 AM every morning under the
following condition.
Standby (TV turned Off with the remote control)
Recording is not in progress.
To update manually
Perform “System Update Search Now” (p. 27)
If there is an update available, a notification banner is displayed.
During downloading, do not turn Off the TV or touch any buttons.
(The TV is automatically activated after downloading is completed.)
When the TV is switched to standby, there will be a clicking sound after a short delay. Similar clicking
sounds will also occur at 3:00 AM and 5:00 AM when “Auto update Search in Standby” (p. 27) is set
to “On”. These sounds are normal.
Note
TH-L26X10A_EN.indb 48
TH-L26X10A_EN.indb 48
8/7/09 10:05:26 AM
8/7/09 10:05:26 AM
