Panasonic VDR-D210P, Service Manual

Page: 32 / 73

Panel Holder Unit
LCD Panel
Reflect Sheet
Adhesive
tape
Adhesive
tape
Portion A
Portions B
Adhesive
tape
Lead Light Panel
(stripe)
(stripe)
BEF Sheet A
BEF Sheet
Diffusion Sheet
(white)
Fig. D13-2
13. Installation of LCD Panel, Reflect Sheet, Lead Light
Panel, Diffusion Sheet, BEF Sheet, BEF Sheet A and
Panel Holder Unit
a. When replacing the LCD Panel, the Diffusion Sheet,
the BEF Sheet and the BEF Sheet A, make sure to
remove the Protection Sheets.
To distinguish Sheets from attached Protection
Sheet:
- A blue Protection Sheet is affixed to both faces of the
Diffusion Sheet.
- A green Protection Sheet is affixed to both faces of the
BEF Sheet.
- A green Protection Sheet is affixed to both faces of the
BEF Sheet A.
(green)
(blue)
(green)
Protection Sheet
Protection Sheet
Protection Sheet
BEF Sheet A
BEF Sheet
Diffusion Sheet
b. Use extreme care when handling the LCD Panel, the
Reflect Sheet, the Lead Light Panel, the Diffusion
Sheet, the BEF Sheet and the BEF Sheet A to avoid
damage, dust, and spots (especially fingerprints, etc.)
Install in order shown below.
1) Install in order: the BEF Sheet A, BEF Sheet and
Diffusion Sheet while fitting the corners of each sheet
into the corners of the Panel Holder Unit.
2) Install the Lead Light Panel while fitting the corners into
the corners of the Panel Holder Unit.
3) Place the Reflect Sheet so it is aligned with Portion A
of the Panel Holder Unit, then install it using the
adhesive tape portions of the Reflect Sheet.
Reflect Sheet
Do not touch
the surface of
Lead Light Panel.
Panel Holder Unit
Adhesive
tape
Adhesive
tape
Fig. D13-1
4) Install the LCD Panel with adhesive tape so it is aligned
with Portions B of the Panel Holder Unit.
32
VDR-D210P / VDR-D220P / VDR-D230P / VDR-D210PC / VDR-D220PC / VDR-D230PC