16
English
Fitting procedure
ツ
Tighten up the screws for securing unit
㇜
, which was secured loosely in section 4, until it will go no further.
Note
• Tightening up the screws for securing unit
㇜
too much may cause the bracket to be bent out of shape.
ヅ
Lift the plasma display slightly, and check that it is firmly secured in place.
Horizontal installation
Vertical installation
Removing the plasma display
ヂ
Place a soft blanket or piece of cloth underneath the plasma display.
Otherwise, the screws for securing unit
㇜
may drop down by mistake,
leaving marks on the surface of the floor.
ッ
Remove the screws for securing unit
㇜
which is attached to the side
of the wall-hanging bracket.
Horizontal installation Left and right side of wall-hanging bracket
Vertical installation Top and bottom of the left side of the wall-
hanging bracket
ツ
Disconnect the power cord and the wires connecting the plasma
display to the other units.
ヅ
While lifting the bottom part of the plasma display, pull the plasma
display toward you.
テ
After the bottom insulation spacers have been removed, continue
lifting up the plasma display and remove it.
Note
• The plasma display needs to be lifted up approximately 4 cm
(1.6 inches) to be removed.
Screw for securing unit
㇜
(Tightening torque: 1.2 to 1.5 N•m)
Screw for securing unit
㇜
(Tightening torque:
1.2 to 1.5 N•m)
Lower
insulation
spacer
テ
ヅ
Blanket or piece
of cloth
Floor surface
Screw for securing unit
㇜
Surface of wall
Surface of wall
Summary of Contents for TY-WK65PR20
