English
16
Video settings
By installing this terminal board in a compatible display,
video and audio settings can be made by using the
display.
For projector
Please refer to the operating instructions of the
projector.
For flat panel display
The description of video settings below is based on
the flat panel display LQ series as an example.
(“SDI settings” for “Setup” menu)
Interface
[SLOT1/SLOT2]
Quad
Audio select
SDI1
SDI2
SDI3
SDI4
Single/Dual
Interface
[SLOT1]
Dual
Audio select
SDI1
SDI2
Single
Interface
[SLOT2]
Dual
Audio select
SDI3
SDI4
Single
Interface [SLOT1/SLOT2]
Select either the independent or the synchronous
operation when 2 units of this board are attached.
Quad:
4K display by synchronizing 2 units
Single/Dual:
Independent operation (Single or Dual
display on each board)
Interface [SLOT1]
When the independent operation is selected, select the
type of 2 inputs for SLOT1 from either Dual or Single.
Dual:
Synchronizes 2 inputs and displays the image
in 1 screen.
Single:
Displays respective images in each single
screen without synchronizing 2 inputs.
Interface [SLOT2]
When the independent operation is selected, select the
type of 2 inputs for SLOT2 from either Dual or Single.
Dual:
Synchronizes 2 inputs and displays the image
in 1 screen.
Single:
Displays respective images in each single
screen without synchronizing 2 inputs.
Audio select
Select the audio signal multiplexed to the SDI signals.
For channel selection, see “Adjusting audio” in the
operating instructions for the display.
SDI1:
Audio signal superimposed on SDI 1
SDI2:
Audio signal superimposed on SDI 2
SDI3:
Audio signal superimposed on SDI 3
SDI4:
Audio signal superimposed on SDI 4
Note
●
When an SD signal or HD signal is displayed in the
“Single/Dual” mode, the audio signal is fixed to the
signal superimposed on the selected signal.
●
Unavailable functions are grayed out on the menu,
and cannot be selected. For example, when “Quad”
is selected for “Interface [SLOT1/SLOT2]”, then
“Interface [SLOT1]” or “Interface [SLOT2]” is grayed
out. The functions described hereafter have been
designed in the same way.
For example, when “SD” is selected for “Format”,
then “4K division”, etc. are grayed out and cannot be
selected.
SDI settings
Make settings for each SDI input terminal.
This shows a setting example for SDI 1 (Do the same for
SDI 2 to 4 as well.)
For projector
Please refer to the operating instructions of the
projector.
For flat panel display
The description of SDI settings below is based on
the flat panel display LQ series as an example.
(“SDI settings” - “SDI1 settings” for “Setup” menu)
Format
SD
1280
1920
2048
3840
4096
4K division
SQUARE
INTERLEAVE
SDI mode
1.5G HD-SDI
3G LEVEL A
3G LEVEL B-DL
3G LEVEL B-DS
Sampling structure
4:2:2
4:4:4
Bit depth
8BIT
10BIT
12BIT
Colour space
YCBCR
RGB
XYZ