Panasonic TX-51P100H L, Service Manual

Page: 25 / 108

- 25 -
CONVERGENCE ADJUSTMENT
SHEET (For PAL / SECAM) CONVERGENCE ADJUSTMENT
SHEET (For NTSC)
86
86
86
86
86
86
86
86
86
86
86
86
517
1034
389
778
89
89
90
89
89
89
89
90
PAL / SECAM
86
85
85
85
86
85
85
86
85
85
85
86
517
1034
389
778
93
92
92
92
92
92
93
92
NTSC
Convergence Adjustment
The convergence adjustment is set separately for
each 50Hz/ 60Hz input (NTSC, PAL/ SECAM). The fol-
lowing explanation uses the PAL mode as an example,
since the same procedure applies to the convergence
adjustment for NTSC mode.
When replacing the following Parts.
IC7101 (EEP-ROM in Digital Convergence Circuit)
L551 (Pincushion Coil)
High Voltage Producing Parts
Other Parts (If change the convergence)
Create an Adjustment Sheet by tracing the following
specifications in their actual size on transparent film or
tracing paper.
Then adjust the convergence.
When replacing one of the CRT’s.
Adjust the convergence for each of the 50Hz and
60Hz inputs so that they are aligned with the other
colours.
Helpful Hint
All positions which have been adjusted are recorded
within P-2 for NTSC data and P-3 for PAL data of the
memory.
This data can be copied to P-4 memory area, allowing
you to perform the adjustment of P-2 (NTSC) and P-3
(PAL).
To perform these adjustments, push the SEARCH but-
ton on the remote control, and manipulate the position
[
] and [ ] button and the "N" button as instructed by
the On Screen Display in P CONVERGENCE adjust-
ment.
All of the Convergence Control Charts have been
listed for the remote control buttons after the Conver-
gence Adjustment Procedure Please refer to these.
(Page 29 and 30)