Panasonic TX-50EX750B, Manual

Page: 147 / 346

Note
●
TV Guide may also be used to set timer event.
Watching > TV Guide > Timer Programming
●
Timer Programming can store up to 15 events.
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using Timer Programming , the TV must be either on or in
Standby.
●
Depending on the progress of recording, analogue channel may not be
selected.
●
Recording an encrypted (copy-protected) programme may not be possible.
●
When the start time comes, the channel may be switched automatically
and the video and audio signals may be output. 2 minutes before the start
time, a reminder message may appear if you are watching TV.
– To remove the message and start the programming, press
OK .
– To cancel the programming, press EXIT .
●
LED turns to orange in Standby mode when Timer Programming is set.
●
“!” identifies that three or more timer events are overlapped. As for
the overlapped recording events, the first event starts and finishes as
programmed. The next event can then start.
●
“!” identifies that two or more timer events are overlapped. As for the
overlapped recording events, the first event starts and finishes as
programmed. The next event can then start.
●
The recording of Timer Programming may automatically change the
channel to the programmed channel a few seconds before the start time.
●
The recording of Timer Programming automatically changes the channel to
the programmed channel a few seconds before the start time.
●
For details of the USB HDD
Recording > Technical information
- 147 -