Panasonic TX-36PD30, Operating Instructions Manual

Page: 3 / 40

Example 2
Example 1
3
D
This TV set is designed to operate on 220
--
240V, 50Hz A.C.
D
To prevent fire, never place any type of candle or naked
flame on top of, or near the TV set.
D
To prevent damage which might result in electric shock or
fire, do not expose this TV set to rain or excessive moisture.
This TV must not be exposed to dripping or splashing water
and objects filled with liquid, such as vases, must not be
placed on top of or above the TV.
D
WARNING : HIGH VOLTAGE !!!
Do not remove the rear cover as live parts are accessible
when it is removed. There are no user serviceable parts
inside.
D
TV Games / Home Computers
Extended use of TV games or home computers with any
television set can cause a permanent ‘shadow’ on the
screen.Thistypeofirreversiblepicturetubedamage,canbe
limited by observing the following points:
D
Reduce the brightness and contrast levels to a minimum
viewing level.
D
Do not operate the television set for a continuous period
of time while using TV games or home computers.
D
This type of picture tube damage, is not an operating
defect, and as such is not covered by the Panasonic
warranty.
D
The On/Off switch on this model does not fully disconnect
the TV from the mains supply. Remove the mains plug from
the wall socket before connecting or disconnecting any
leads or if the TV set is not used for a prolonged period of
time.
Note:
D
If the set is not switched off when the TV station stops
transmitting, it will automatically go to standby mode
after 30 minutes. This function will not operate when the
TV is in AV mode.
D
Cabinet and picture tube care
Remove the mains plug from the wall socket. The cabinet
and picture tube can be cleaned with a soft cloth moistened
with mild detergent and water. Do not use solutions
containing benzol or petroleum. TV sets can produce static
electricity, care must be taken whenever touching the TV
screen.
D
Adequate ventilation is essential to prevent failure of
electrical components, we recommend that a gap of at least
5cm is left all around this television receiver even when it is
placed inside a cabinet or between shelves.
D
Avoid exposing the TV set to direct sunlight and other
sources of heat. To prevent fire, never place any type 0f
candle or naked flame on top or near the TV set.
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY
This appliance is supplied with a fitted three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. If
the fuse is replaced then the replacement fuse must be 5 amp rated and should be approved by ASTA or BSI to BS1362.
Check for the ASTA mark
ASA
or the BSI mark on the body of the fuse.
Ifthefittedplughasaremovablefusecoveryoumustensurethatitisrefittedwhenthefuse
isreplaced.Ifyoulosethefusecovertheplugmustnotbeuseduntilareplacementcoveris
obtained. Replacement fuse covers can be purchased through your local Panasonic
dealer.
The plug fitted to this appliance incorporates a mains filter circuit. If this is removed
or replaced with a non
--
filtered plug this television will no longer meet the European
standardsforElectromagneticCompatibility(EMC).Ifthefittedplugisunsuitablefor
the socket outlet in your home an appropriate adapter should be used.
Nonetheless, if the fitted plug is replaced, the fuse should be taken out and the
cut
--
off plug disposed of safely. There is danger of severe electrical shock if the cut
off plug is inserted into any 13 amp socket.
If a new plug is to be fitted please observe the wiring code as shown below.
If in any doubt please consult a qualified electrician.
How to replace the fuse (for plug type shown in example 1) :
Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refit
securely into the mains plug (see example 1).
How to replace the fuse (for plug type shown in example 2) :
Liftopenthefusecompartment,inthemainsplug,withascrewdriver,andreplacethefuse,
then press the fuse cover down securely (see example 2).
IMPORTANT :
--
The wires in the mains lead of this appliance are coloured in accordance with the following code :
--
BLUE : NEUTRAL BROWN : LIVE
As the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in your
plug, proceed as follows :
--
1. The BLUE wire must be connected to the terminal marked ‘N’ or coloured black.
2. The BROWN wire must be connected to the terminal marked ‘L’ or coloured red.
IMPORTANTNOTE:UndernocircumstancesshouldeitherofthesewiresbeconnectedtotheEarthterminalofthethreepinplug,
marked with the letter ‘E’ or the earth symbol.
Warnings and precautions