![background image](http://html1.mh-extra.com/html/panasonic/toughbook-cf-h1adbazcm/toughbook-cf-h1adbazcm_reference-manual_3628961006.webp)
6
Touch Screen Operation
To improve the outdoor visibility of the display, a low reflection coating has been added. In order to avoid scratches and peel-
ing of this coating, an approved soft cloth has been included to wipe the LCD surface of the computer. Before using the com-
puter, be sure to read the instructions provided below.
<How to use the soft cloth>
• Use the soft cloth when it is dry. Do not apply water or solvents to the soft cloth.
• First, lightly wipe foreign particles and dust adhering to the LCD display on one side of the soft cloth. Do not use force,
since the LCD surface may be damaged with the foreign particles or dust.
Next, wipe off fingerprint, etc., with the other side of the soft cloth.
After wiping off foreign particles and dust, wash the soft cloth (refer to the following) to remove the foreign particles and
dust from the soft cloth.
• When the soft cloth becomes dirty, wash it with neutral detergent. Do not use bleach or a fabric conditioner (softener), or
carry out sterilization by boiling.
• If the LCD gets wet, wipe the surface lightly with the soft cloth.
• While wiping the LCD display, the computer must be turned off.
Digitizer Calibration
To calibrate the digitizer, use the digitizer pen and follow the steps below.
1
Run [Tablet PC Settings].
Click
(Start) - [Control Panel] - [Hardware and Sound] - [Tablet PC Settings].
2
Click [Calibrate].
3
Select [Pen input].
4
Touch each of the 4 “+” target marks one by one.
5
Click [Yes].
Suggestions About Cleaning the LCD Surface
z
Be sure to wipe the LCD display to remove fingerprints, etc., with the soft cloth.
z
Do not wipe areas other than the LCD display with the soft cloth.
Calibration