2
First-time Operation
“OPERATING INSTRUCTIONS
(page 9)
”
Replace the step
6
for the following.
“OPERATING INSTRUCTIONS (page 10)”
6
Turn your computer on
Federal Communications Commission Radio Frequency Interference Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the Panasonic Service Center or an experienced radio/TV technician for help.
Warning
To assure continued compliance, use only shielded interface cables when connecting to a computer or peripheral. Also, any changes or
modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Responsible Party: Matsushita Electric Corporation of America
One Panasonic Way
Secaucus, NJ 07094
Tel No:1-800-LAPTOP-5
(1-800-527-8675)
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and your body (excluding
extremities: hands, wrists, and feet) and must not be co-located or operated with any antenna or transmitter.
For U.S.A.
Replace the step
8
for the following.
“OPERATING INSTRUCTIONS (page 11)”
3
Select [Advanced] menu, then set [Wireless LAN] to
[Disable].
4
Press
F10
.
At the confirmation message, select [Yes], then press
Enter
.
8
Setup Windows
Moving the cursor (
) or clicking buttons can be per-
formed with the touch pad.
1
At the [Welcome to the Windows 2000 Setup Wiz-
ard], select [Next].
2
After reading the agreement, select [I accept this
agreement] or [I don’t accept this agreement], then
select [Next].
Windows 2000
Do not press any key or move the touch pad until
[Windows 2000 Professional Setup] is displayed.
CAUTION
NOTE
If [I don’t accept this agreement] is selected, the
Windows setup will be aborted.
1
Slide the power switch and hold it for approximately
one second until the power indicator turns on before re-
leasing it.
2
When [Press F2 to enter SETUP] is displayed, press
F2
, then run the Setup Utility.
