CAUTION
1
2
1. When Using the Battery
Danger
(1) Misusing the battery may cause the battery to get hot, explode,
or ignite and cause serious injury. Be sure to follow the safety rules
listed below:
- Do not place the battery in fire or heat the battery.
- Do not install the battery backwards so that the polarity is reversed.
- Do not connect the positive terminal and the negative terminal of the
battery to each other with any metal object (such as a wire).
- Do not carry or store the batteries together with necklaces, hairpins,
or other metal objects.
- Do not pierce the battery with nails, strike the battery with a hammer,
step on the battery, or otherwise subject it to strong impacts or shocks.
- Do not solder directly onto the battery.
- Do not expose the battery to water or salt water, or allow the battery
to get wet.
(2) Do not disassemble or modify the battery. The battery contains
safety and protection devices which, if damaged, may cause the
battery to generate heat, explode or ignite.
(3) Do not place the battery on or near fire, stoves, or other high
temperature locations. Do not place the battery in direct sunlight,
use or store the battery inside cars in hot weather. Doing so may
cause the battery to generate heat, explode, or ignite.
Using the battery in this manner may also result in a loss of
performance and a shortened life expectancy.
(4) Do not insert the battery into equipment designed to be hermetically
sealed. In some cases hydrogen or oxygen may be discharged from
the cell which may result in rupture, fire or explosion.
CAUTION :
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
(Please refer to instruction for safe disposal of lithium
polymer battery at page#3)
This device complies with Part 15 and RSS-GEN of the FCC and IC rules.
Operation is subject to the following conditions;
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
CAUTION : Changes or modifications not expressly approved by the party
responsible for compliance could Void the user’s authority to operate this
device.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65. The belt clip is only applied to the TX.
The use of belt-clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that do not
satisfy these requirements may not comply with FCC RF exposure
requirements, and should be avoided.
