Panasonic TK-AS700, Operating Instructions Manual

Page: 19 / 44

EN19
Ins
tal
lation
Engli
sh
3
After completing the preparations,
connect the water supply hose.
 


Remove the hose fastening nut from the bypass
selector, and pass the hose through the nut.

Insert the water supply hose into the bypass
selector as far as it will go.
<OK>
<NG>
Gap

Tighten up the hose fastening nut securely.
 Do not use any tools for this assembly (since the hose fastening nut may be damaged)
4
Using the hose strap,
Secure the water supply hose.
 Be sure to fi x the water supply hose. (Water leakage may occur.)
5
Screw in the outlet pipe until it is secured fi rmly.
 Do not use any tools for this assembly (since the pipe may be damaged).
 Ensure that the packing does not come off or protrude from the groove, preventing it from twisting.
(since this may cause the water to leak).
 Do not lift the unit by taking hold of the outlet pipe (otherwise damage may result).
6
Secure the drain hoses using
the suction disc.
 Do not place a garbage bin under the
drain hose.
Height diff erence
(20~50 cm)
Lower than 10 cm
The tip of the drain hose must be lower than the bottom of the main unit, or the height diff erence between
the tip of main spout and the tip of the drain hose must be more than 20 cm and less than 50 cm.
[ So that the appropriate pH level (ion exponent) is achieved ]
7
Connect the power plug to the power outlet
(AC 220 V - 240 V)
.
 The buzzer beeps, and the water quality indicator of “Purifi ed” lights up. (The LCD display changes as Language → Until cartridge
replacement → Preparation time (15 seconds) → Purifi ed → Until cartridge replacement, and turns off after approx. 50 seconds.)
 The Alkaline Ionizer’s power consumption is 1 W even in the standby status.
Important
 If the hose is too long, it is recommended that you cut it to the proper length (cut it straight down).
 Do not bundle the hose as one. Do not fi x the hose in such a way that the hose fl oats. (Water remaining in the hose may cause odor.)
 After installation, run water for 3 to 4 minutes to eliminate the air inside the main unit.
 While water is fl owing after installation, and the countdown are displayed for 20 seconds.
 Do not remove the power plug normally so that the automatic electrode cleaning operates correctly and the
cartridge life is displayed correctly. (P. EN29, EN31)
TK-AS700_En.indb 19 TK-AS700_En.indb 19 2022/06/23 14:07:45 2022/06/23 14:07:45