Panasonic TH-80SF2HU, Operating Instructions Manual, Page: 10 / 27

English
10
Notes on Using Wired LAN
When setting up the Display at a place, where
electric statistic occurs often, take a sufficient
antistatic measure before start using.
•
When the Display is used at a location, where static
electricity occurs often, such as on a carpet, a wired
LAN or DIGITAL LINK communication is disconnected
more often. In that case, remove static electricity
and the noise source that may cause problems with
an antistatic mat, and re-connect the wired LAN or
DIGITAL LINK.
•
In rare cases, the LAN connection is disabled due
to static electricity or noise. In that case, turn off the
power of the Display and the connected devices once
and then re-turn on the power.
The Display may not work properly due to strong
radio wave from the broadcast station or the radio.
•
If there is any facility or equipment, which outputs
strong radio wave, near the installation location, set
up the Display at a location sufficiently far from the
source of the radio wave. Or, wrap the LAN cable
connected to the DIGITAL LINK / LAN terminal by
using a piece of metal foil or a metal pipe, of which is
grounded at both ends.
Request Regarding Security
When using this unit, take safety measures against
the following incidents.
•
Personal information being leaked via this unit
•
Unauthorized operation of this unit by a malicious
third party
•
Interfering or stopping of this unit by a malicious third
party
Take sufficient security measures.
•
Set a password for the LAN control and restrict the
users who can log in.
•
Make your password difficult to guess as much as
possible.
•
Change your password periodically.
•
Panasonic Corporation or its affiliate companies will
never ask for your password directly. Do not divulge
your password in case you receive such inquiries.
•
The connecting network must be secured by a
firewall, etc.
•
When disposing the product, initialize the data before
disposing. [Shipping]
LightID
•
When using a laser barcode reader, prevent a
barcode surface from being exposed to the screen
light. The barcode reading may be impossible or
incorrect.
•
When shooting the screen using a security camera,
etc., a striped pattern may appear on the shot image.
•
In a location exposed to direct sunlight or surrounded
by a bright light, the LightID may not be received
or reception performance for the LightID may be
degraded due to the influence of the surrounding
light.
Cleaning and maintenance
First, remove the mains plug from the mains socket.
Gently wipe the surface of the liquid crystal panel or
cabinet by using a soft cloth to remove dirt.
•
To remove stubborn dirt or fingerprints on the surface
of the liquid crystal panel, dampen a cloth with diluted
neutral detergent (1 part detergent to 100 parts
water), wring out the cloth firmly, and then wipe away
the dirt. Finally, wipe away all the moisture with a dry
cloth.
•
If water droplets get inside the unit, operating
problems may result.
Note
● The surface of the liquid crystal panel is specially
treated. Do not use a hard cloth or rub the surface
too hard, otherwise this may cause scratches on the
surface.
Usage of a chemical cloth
•
Do not use a chemical cloth for the liquid crystal panel
surface.
•
Follow the instructions for the chemical cloth to use it
for the cabinet.
Avoid contact with volatile substances such as
insect sprays, solvents and thinner.
•
This may degrade surface quality or cause peeling of
the paint. Furthermore, do not leave it in contact with
a rubber or PVC substance for a long time.
Disposal
When disposing the product, ask your local
authority or dealer about the correct methods of
disposal.