Panasonic TH-43DS630U, E-Manual

Page: 92 / 268

Note
●
TV Guide may also be used to set timer event.
Watching > TV Guide > Timer Programming
●
Timer Programming can store up to 15 events.
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using Timer Programming , the TV must be either on or in
Standby. For reminders to be displayed, the TV must be on.
●
No other channels can be selected while recording of Timer Programming
is in progress.
●
Recording an encrypted (copy-protected) programme may not be possible.
●
When the start time comes, the channel will be switched automatically and
the video and audio signals will be output. 2 minutes before the start time,
a reminder message appears if you are watching TV.
– To remove the message and start the programming, press
OK .
– To cancel the programming, press EXIT .
●
LED turns to orange in Standby mode when Timer Programming is set.
●
Reminder messages will remain displayed until one of the following
occurs:
– You press
OK to view the programme or EXIT to cancel the reminder.
– The timer event that the reminder is set for ends.
●
“!” identifies that two or more timer events are overlapped. USB HDD Rec.
is given priority over Reminder . As for the overlapped recording events,
the first event starts and finishes as programmed. The next event can then
start.
●
The recording of Timer Programming automatically changes the channel to
the programmed channel a few seconds before the start time.
●
The recording of Timer Programming is performed even if the TV is
in REW LIVE TV recording. In this case, REW LIVE TV recording is
cancelled.
Recording > Recording current programme > REW LIVE TV
●
For details of the USB HDD
Recording > Technical information
- 92 -