5. Tighten the mounting bolts.
• Be sure to fix the left side fixing screws to
stabilize the display.
3. Attach the insulation spacers to the display.
Remove the four bolts from the display.
In the holes that previously held the 4
M8 bolts, insert the insulating spacer,
toothed pan washer, and pan head
bolt with hex socket (4 each) that came
with the wall-hanging bracket.
Remove M8 bolts
Fixing
A
B
C
Pan head bolt with hex socket
Toothed pan washer
Insulating spacer
A
B
C
4. Install the display to the wall-hanging bracket.
Position the display so that the power switch is located at the bottom.
Insulating spacer
Power
switch
Top holes
Lower
holes
• Do not lift the display too high, otherwise it
may become unhooked.
Push the upper insulating spacers
on the display into the notches at
the top of the wall-hanging bracket
until they are hooked in, then lower
the display into place.
While lifting the display slightly,
insert the lower insulating spacers
on the display into the lower
hanging holes in the wall-hanging
bracket, then lower the display.
Tighten the fixing screws on the left
side.
;
;
;
Bolt locations
(upper and lower)
(Left side view)
Note
Note
5
