Panasonic TH-42LFP30W, Service Manual

Page: 21 / 58

21
TH-42LFP30W / TH-47LFP30W
8.3. Removing back plate
1. Turn to loosen the waterproof nut which secures the
power cord onto the back plate and remove the nut.
2. Open the slit of the rubber packing which is located inside
the waterproof nut to remove the rubber packing from the
power cord.
Be careful not to pull the power cord while removing the
back plate following this procedure.
3. Remove the screws which hold the back plate.(Model
47V: 26 screws; Model 42V: 24 screws) (SPECIAL
SCREW 4X12)
4. Hold handle and lift the back plate slightly.
5. Insert your hand through the opening gap while lifting the
back plate. Detach the cable which runs from the main
switch board mounted on the back plate, off the hook and
remove the connector K39G for the jack board.
6. The back plate also can be lifted with the power cord run-
ning through it. If you remove the back plate together with
the power cord, carry out the following procedure.
7. Detach the power cord off the hook, and remove the cou-
pler K601 from the power board. Next, remove the screws
which hold the earth pin for the power cord.
• For Model 47V, the hook for the power cord is fixed with
screws. Undo screws to remove the hook.
8. Gently remove the back plate.