Panasonic TH-37PR10A, Operating Instructions Manual

Page: 9 / 52

9
Connections
1
6 7 8
3
9
4 5
10
15 14 13 12 11
2
Notes:
• Due to space limitations, occasionally you may have trouble connecting Mini D-sub 15P cable with ferrite core to PC input
Terminal.
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 768 × 720 dots (TH-37PR10M, TH-37PR10A), 768 × 768 dots (TH-42PR10M,
TH-42PR10A), 640 × 480 dots (TH-42PG10M, TH-42PG10A) when the aspect mode is set to “4:3”, and 1,024 × 720
dots (TH-37PR10M, TH-37PR10A), 1,024 × 768 dots (TH-42PR10M, TH-42PR10A), 852 × 480 dots (TH-42PG10M,
TH-42PG10A) when the aspect mode is set to “16:9”. If the display resolution exceeds these maximums, it may not
be possible to show
fi ne detail with suf fi cient clarity.
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will
need to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the speci
fi ed
frequency range.
• Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.
• Change the “Component/RGB-in select” setting in the “Setup” menu to “Component” (when Component connection)
or “RGB” (when RGB signal connection). (see page 33)
Signal Names for Mini D-sub 15P Connector
Pin Layout for PC Input
Terminal
PC Input Terminals connection
AUDIO
PC IN
COMPUTER
Conversion adapter
(if necessary)
Mini D-sub 15p
RGB
PC cable
Stereo plug
Audio
Connect a cable which matches
the audio output terminal on the computer.
Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name
1 R (P
R
/C
R
) 6 GND (Ground) 11 NC (not connected)
2
G (Y)
7
GND (Ground)
12
SDA
3
B (P
B
/C
B
)
8
GND (Ground)
13
HD/SYNC
4 NC (not connected) 9 NC (not connected) 14 VD
5
GND (Ground)
10
GND (Ground)
15
SCL