Panasonic SL-VVMES2, Instruction Manual, Page: 7 / 22

6
8) Error indicator (Red)
It lights up when an error occurs on the S-LINK V system main cable. In case the cause of the er-
ror is eliminated, it blinks, and if the error No. is cleared with program, or when the system setting
is done, it turns OFF.
Notes: 1) Error 0 to Error 6 cannot be distinguished with the error indicator. Check with a program on the
VME bus system by using “ 5) HL00 + 004A to B, HL00 + 014A to B: Error No. / Error state ” in “ 5.
Assignment on Program .”
2) In case of turning OFF the blinking state, operate on the program.
Set the interruption level (IRQ1 to IRQ7) of VME bus.
In case an error occurs on the
S-LINK V system main line or the input of the input unit is
changed, it processes at the interruption level that is set with the interruption level setting switch.
The above figure indicates the
interruption level “IRQ1.”
0 1
SW8
1
2
3
4
5
6
7
8
O
N
Level 1 2 3 4 5 6 7 8
Unused OFF OFF OFF
OFF
IRQ1 ON OFF OFF
IRQ2 OFF ON OFF
IRQ3 ON ON OFF
IRQ4 OFF OFF ON
IRQ5 ON OFF ON
IRQ6 OFF ON ON
IRQ7 ON ON ON
Note: Settings other than the above diagram is invalid.
10) Status / ID setting switch (SW7)
Set the status / ID that is transferred when VME bus is interrupted, in binary digit.
bit 0: undermost, bit 7: uppermost, “ON” = 1, “OFF” = 0.
Note: Transfer capability of status / ID is D08 (O).
T h e a b o v e f i g u r e
shows “binary digit =
01100101,” and “hexa-
decimal = 65.”
SW7
1
2
3
4
5
6
7
8
O
N
0 1
bit 1 0
1 0 (2
0
)
ON OFF
2 1 (2
1
)
3 2 (2
2
)
4 3 (2
3
)
5 4 (2
4
)
6 5 (2
5
)
7 6 (2
6
)
8 7 (2
7
)