OFF, press the VOL+, VOL-,
, and
buttonson the remote
controller within two seconds. (as shown in
Fig. 5
)
3. When entering the main unit’s key check mode, “ KEY EX ” will be
displayed on the LCD of main unit and “ T KEX ” will be displayed
on the LCD of remote controller. (If it is notdisplayed, perform the
procedures written above again.)
4. Confirm the display of LCD by pressing any keys on the main unit.
There is no order to press the keys.
Mian unit’s keys LCD display positions and letters
HOLD OFF
1st. 2nd. letters are AA
REC PAUSE
3rd. 4th. letters are BB
EDIT
5th. 6th. letters are CC
STOP
7th. 8th. letters are DD
PLAY
9th. 10th. letters are EE
5. Remote controller’s LCD lights “ T ” and main unit’s LCD
lights all when you can detect all keys.
6. Perform below voltage check about the keys come under if you
cannot detect the key.
Main unit’s keys
Check points
ON
OFF
HOLD
IC501 55pin
0V
2.4V
REC PAUSE
IC501 49pin
0V
2.4V
EDIT
IC501 3pin
1.94V
2.4V
STOP
IC501 3pin
0V
2.4V
PLAY
IC501 48pin
0V
2.4V
7. When the keys are ready for detection, press the PLAY key of the
remote control.
8. Pressing each key mounted to the main body, make sure of
displayed three letters (4th ~ 6th letters) on the right side of the
remote control. / Keys to be pressed are not in order. / When the
3 keys apportioned to the respective letters asshown below are all
OK, “ 0 ” is displayed.
22