21
RQT6611
20
RQT6611
Operating
Instructions
Operating Instructions
Operating Instructions
Location of Controls
Refer to the illustrations on pages 6 to 7.
∫
Main unit
1
Open switch (OPEN
1
)
2
Earphone/MD Network jack (
Ë
)
3
Hold switch (HOLD
1
)
4
Play/stop button (
1
/
∫
)
5
Skip/search buttons (
:
,
9
)
6
Volume control buttons (VOL
i
, VOL
j
)
7
LED indicator
Flashes when a button on the main unit
or remote control is pressed
8
Rechargeable battery compartment
cover
9
Connection terminal for battery case
∫
Remote control
:
Hold switch (HOLD
1
)
;
Display
<
Skip/search(backward) button (
:
)
=
Volume control buttons (
i
,
j
)
>
Play/stop button (
1
/
∫
)
?
Skip/search(forward) button (
9
)
@
Earphone jack
A
Light/display button (
$
LIGHT/
%
DISP)
B
Play mode button (PLAY MODE)
C
Tone control/memory button
(EQ/MEMORY)
D
Clip
E
Plug
∫
Stereo earphones
F
Slider
Slide up to prevent tangling the cord
when the earphones are not in use.
G
Plug
∫
Display information
H
Number of tracks/track number
I
Text/play time
J
Tone quality
K
Play mode
L
Battery indication
The HOLD Function
Refer to the illustration on page 9.
This function disables buttons so that power
cannot be turned on or play interrupted
accidentally.
Even if HOLD is activated on the main
unit, you still operate the remote control.
Even if HOLD is activated on the remote
control, you still operate the main unit.
Other functions
Playback (Basic play)
Refer to the illustrations on pages 10 to 11.
Tracks recorded in MDLP (Extended Play
Recording; LP2, LP4) and monaural mode are
automatically detected and played back accordingly.
1 Connect the remote control and
earphones, then insert the remote
control’s plug into the earphone jack
[
Ë
] on the unit.
2 Release HOLD.
3 Insert an MD. (page 20)
Reads disc information. The unit waits for
10 seconds and if no button is pressed
turns itself off.
4 Press [
1
/
∫
] to start play.
≥
Playback begins and the LED flashes in the
following colors:
≥
Monaural, normal stereo . . . . . .orange
≥
LP2 . . . . . . . . . . . . . . . . . . . . . . .green
≥
LP4 . . . . . . . . . . . . . . . . . . . . . . .red
≥
The unit stops automatically when all the
tracks on the disc have been played.
5 Adjust the volume.
To stop the disc
Press [
1
/
∫
].
After about 10 seconds the power goes off
automatically.
≥
If play is pressed, playback resumes from
the point where it left off (RESUME function).
If the unit is opened or the battery is
changed, play starts from the first track.
Skip
Press [
:
,
9
].
≥
When the unit is stopped, use these
buttons to select a track and press [
1
/
∫
]
to begin play from that track (track
selection function).
Search
Press and hold [
:
,
9
] during play.
∫
Checking the display
Button press - lights for 5 seconds.
When scrolling - lights for 20 seconds maximum.
≥
To turn the display on
Press [
$
LIGHT/
%
DISP].
∫
Turning the remote control beep
On and Off
1 Put the main unit in hold. (page 20)
2 While pressing [
1
/
∫
] on the main unit, press
[
1
/
∫
] on the remote control for about 5 seconds.
Every time this is carried out the setting switches
between Off (BeepOFF) and On (BeepON).
∫
Adjusting contrast
1 Put the main unit on hold during play or
while play is stopped.
2 While pressing [
1
/
∫
] on the main unit,
press [
i
] (stronger) or [
j
] (weaker) on the
remote control.
CONT 15 (strong)
j
CONT 0 (weak)
Insert an MD
Refer to the illustration on page 7.
1 Slide [OPEN
1
] in the direction of
the arrow to open the lid.
2 Slide the MD between the guides so it
clicks into place. The MD springs out
again slightly.
3 Now close the lid. The MD is retracted
into position.
∫
Removing the disc
Slide [OPEN
1
] in the direction of the
arrow and the disc springs out from the unit.
Power source
Refer to the illustrations on pages 8 to 9.
The rechargeable battery (included)
1 Insert the battery into the unit.
2 Connect the AC adapter to the battery
charger stand.
3 Put the unit on the stand.
The LED and recharging indicator flash
during recharging.
If the interval between flashes becomes long
(about 5 seconds), recharging is complete.
∫
Recharging and playback times
Recharging time : Approx. 3.5 hours
Play time :
Normal stereo mode: Approx. 40 hours
※
LP2 stereo mode: Approx. 53 hours
※
LP4 stereo mode: Approx. 70 hours
※
When playing MDs recorded with
MDLP mode.
Dry cell battery (not included)
Use one LR6 Panasonic alkaline battery.
1 Put the battery into the battery case.
2 Attach the case to the unit.
≥
Using both rechargeable and dry batteries
together greatly increases battery lasting time.
≥
By turning off the LED you can reduce the
rate at which the battery is depleted.
∫
LED On and Off
Preparation: Connect the remote control and
the stereo earphone to the main
unit. (page 21)
1 Close the lid without inserting a disc.
2 While “NoDISC” is displayed,
Press [
$
LIGHT/
%
DISP] for about 5 seconds.
Every time the button is pressed the
setting switches between Off (LED OFF)
and On (LED ON).
≥
The LED cannot be turned off when
recharging.
∫
The battery indicator
If playback is continued when the indicator is
flashing, the power will be turned off.
Refer to the illustrations on pages 12 to 13.
Listening to a song group
Groups of tracks can be created on an MD
using an MD recorder. A disc set to group in
this way allows you to start play from a
specified group on the MD. You cannot set a
disc to group using this unit.
To cancel “INTRO” or “MEMO” on display,
press [PLAY MODE]. (page 22)
1 Press and hold [PLAY MODE] while stopped
to select “
＊
GRPON” (group mode).
The group mode and disc mode change
each time the button is pressed.
＊
GRPON
()
GRPOFF (disc mode)
2 Press and hold [
:
,
9
] to select the
group you want to listen to.
3 Press [
1
/
∫
] to start play.
Playback starts with the first track in the
group and continues through to the last.
e
≥
You may search or skip tracks within the group.
≥
Discs not set to group mode cannot be used
in group mode. “NO GRP” is displayed.
≥
If the lid is opened or the battery is
changed the setting returns to disc mode.
Repeat and Random play
Each time [PLAY MODE] is pressed:
1-
`
(Repeat once)
( ----------------------------]
;
|
`
(Repeat all tracks)
|
;
|
RANDOM (Listen at random)
|
;
|
Only while the unit is stopped in disc mode
|
INTRO or MEMO (Introscan Memory)
|
(page 22)
|
;
|
Release (No indicator is shown)
-----------------}
≥
Songs are repeated or played back at random
within the group when in group mode.
≥
It is not possible to skip or search to a track that
has already been played during random play.
≥
If the lid is opened or the battery is changed
the unit returns to normal playback mode.
Changing battery causes the following
settings to return to the values shown:
Volume -VOL 12, Remote Control beep -ON,
Contrast -CONT10.
∫
Changing Display Contents
Press and hold [
$
LIGHT/
%
DISP].
The display changes each time the button is
pressed.
≥
“
＊
” indicates group mode.
≥
“
” indicates disc names.
≥
“
” appears when a track, group, or
disc has no title.
Note
