Panasonic SH-ALL1C, Owner'S Manual

Page: 28 / 34

- 28 -
The network indicator does not stop blinking in blue and red.
≥
The unit needs to be repaired. Consult your dealer.
This unit has stopped producing operation sounds.
≥
Set the operation sound setting to on. ( l 25)
The mode indicator (amber) keeps blinking twice.
≥
This unit is not connected to the network. Touch any switch, and then
check the network connection. (
l 12)
The mode indicator (amber) keeps blinking three times.
≥
The update has been failed. Touch any switch, and then try again.
≥
When using a LAN cable, make sure to connect the LAN cable while the
AC power supply cord (AC mains lead) is disconnected. (
l 17)
The mode indicator (amber) keeps blinking fast.
≥ An error has occurred. Disconnect the AC power supply cord (AC mains
lead) and reconnect it. Turn the unit on and try again.
Cannot connect to the network.
≥
This unit’s Wi-Fi security supports WPA2™ only. Your wireless router
must therefore be WPA2™ compatible. For details on the security
supported by your router and how to change the settings, please refer to
the operating instructions or contact your Internet service provider.
≥
If the network is set to be invisible, make the network visible while you
set up the network for this unit or make a wired LAN connection. (
l 17)
≥
Make sure that the multicast function on the wireless router is enabled.
≥
Depending on the routers, WPS button may not work. Try other
methods. (
l 12)
Firmware updates
Network