Panasonic SC-UX100, Owner'S Manual

Page: 10 / 48

Confidential
Until:
9 Jan 2017
10
TQ
BJ
09
73
█
Selecting a preset station
1
Press [PLAY MENU] to select “TUNE MODE”.
2
Press [
R
,
T
] to select “PRESET” and then press
[OK].
3
Press [
2
/
3
] or [
5
/
6
] to select the preset
station.
Using the main unit
1
Press [
8
] to select “PRESET”.
2
Press [
2
/
3
] or [
5
/
6
] to select the preset
station.
Improving the sound quality
1
Press [PLAY MENU] to select “FM MODE”.
2
Press [
R
,
T
] to select “MONO” and then press
[OK].
To cancel, select “STEREO”.
“MONO” is also canceled when you change the
frequency.
To memorize the setting
Continue with step 4 of “Manual presetting”.
Checking the signal status
Press [DISPLAY].
FM allocation setting
By main unit only
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
1
Press [RADIO/AUX] to select “FM”.
2
Press and hold [RADIO/AUX].
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• Preset frequencies are erased after you change the
setting.
Clock and timers
Setting the clock
This is a 12-hour clock.
1
Press [SETUP] to select “CLOCK”.
2
Press [
R
,
T
] to set the time and then press [OK].
To check the time
Press [SETUP] to select “CLOCK” and then press
[OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer turns off the system after the set time.
1
Press [SETUP] to select “SLEEP”.
2
Press [
R
,
T
] to select the setting (in minutes) and
then press [OK].
To cancel, select “OFF”.
Note:
• The remaining time is shown for a few seconds every
minute. “SLEEP 1” is always shown when only 1 minute
remains.
•
The play timer and sleep timer can be used together.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.
Play timer
(Except for Bluetooth ® and AUX source)
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] to select “TIMER ADJ”.
2
Press [
R
,
T
] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [
R
,
T
] to select the source you want to play
and then press [OK].
FM – – – – The FM signal is weak.
The system is not tuned in to a station.
FM ST The FM signal is in stereo.
FM MONO “MONO” is selected as the “FM MODE”.
The FM signal is in monaural.
SC-UX100 PP TQBJ0973 En.fm Page 10 Saturday, August 13, 2016 5:06 PM
digital printing