12
RQT9742
Stations cannot be selected.
Change the FM frequency step.
1
Press [RADIO] to select “FM”.
2
Press and hold [SELECTOR] on the unit.
After a few seconds the display changes to show the
current lowest frequency. Continue to hold the button
down. The lowest frequency changes and the step is
changed.
Cannot charge or operate.
≥
Have you selected the appropriate selector?
Press [iPod] to select either “IPOD_DOCK” or
“IPOD_PORT”.
≥
Check that the iPod/iPhone/iPad is connected properly.
(
l
6)
≥
The battery of the iPod/iPhone/iPad is depleted. Charge
the iPod/iPhone/iPad, and then operate again.
≥
Connect the iPod/iPhone/iPad again or try to restart the
iPod/iPhone/iPad.
≥
When this unit is in standby mode, charging will not start
when using the “IPOD_PORT” connection.
Turn this unit on and make sure the charging has started
before switching this unit to standby mode.
Pairing cannot be done.
≥
Check the Bluetooth
®
device condition.
The device cannot be connected.
≥
The pairing of the device was unsuccessful or the
registration has been replaced. Try pairing the device
again. (
l
7)
≥
This unit might be connected to a different device.
Disconnect the other device and try pairing the device
again. (
l
7)
The device is connected but audio cannot be
heard through this unit.
≥
For some built-in Bluetooth
®
devices, you have to set the
audio output to “SC-HC38” manually. Read the operating
instructions for the device for details.
The sound is interrupted.
≥
The device is out of the 10 m (33 ft) communication
range. Bring the Bluetooth
®
device closer to this unit.
≥
Remove any obstacle between this unit and the device.
≥
Other devices that use the 2.4 GHz frequency band
(wireless router, microwaves, cordless phones, etc.) are
interfering. Bring the Bluetooth
®
device closer to this unit
and distance it from the other devices.
≥
Select “MODE1” for stable communication. (
l
7)
The remote control doesn't work properly.
≥
The remote control and this unit are using a different
code. (
l
13, “REMOTE ”)
≥
Is the battery depleted or is the battery inserted
incorrectly? (
l
4)
The following messages or service numbers
may appear on the unit's display.
“--:--”
≥
You plugged the AC power supply cord in for the first
time or there was a power failure recently. Set the time
(
l
10).
“ADJUST CLOCK”
≥
Clock is not set. Adjust the clock accordingly.
“ADJUST TIMER”
≥
Play timer is not set. Adjust the play timer accordingly.
“AUTO OFF”
≥
The unit has been left unused for about 30 minutes and
will shut down within a minute. Press any button to
cancel it.
“CANNOT SET”
≥
Select an audio source other than “BLUETOOTH”.
“CHECKING CONNECTION”
≥
The unit is checking the connected iPod/iPhone/iPad.
≥
If this display keeps appearing, make sure that the
battery of the iPod/iPhone/iPad is not depleted and that
the iPod/iPhone/iPad is turned on and connected
correctly. (
l
6)
“DIMMER”
≥
Appears 10 seconds after the volume is turned to “0”.
“ERROR”
≥
Incorrect operation is performed. Read the instructions
and try again.
“F
” (“ ” stands for a number.)
≥
There is a problem with this unit.
Note down the displayed number, disconnect the
AC power supply cord and consult your dealer.
iPod/iPhone/iPad operations
Bluetooth
®
Remote control
Messages
SC-HC38~RQT9742.book Page 12 Tuesday, December 11, 2012 2:20 PM
