![background image](http://html1.mh-extra.com/html/panasonic/sc-all9/sc-all9_operating-instructions-manual_3883701023.webp)
SQT1211
23
The mode indicator (amber) keeps blinking
twice.
≥
This unit is not connected to the network.
Touch any switch, and then check the
network connection. (
l
7)
The mode indicator (amber) keeps blinking
three times.
≥
The update has been failed. Touch any
switch, and then try again.
≥
When using a LAN cable, make sure to
connect the LAN cable while the AC mains
lead is disconnected. (
l
10)
The mode indicator (amber) keeps blinking
fast.
≥
An error has occurred. Disconnect the AC
mains lead and reconnect it. Turn the unit on
and try again.
Cannot connect to the network.
≥
This unit’s Wi-Fi security supports WPA2
TM
only. Your wireless router must therefore be
WPA2
TM
compatible. For details on the
security supported by your router and how to
change the settings, please refer to the
operating instructions or contact your Internet
service provider.
≥
If the network is set to be invisible, make the
network visible while you set up the network
for this unit or make a wired LAN connection.
(
l
10)
≥
Make sure that the multicast function on the
wireless router is enabled.
≥
Depending on the routers, WPS button may
not work. Try other methods. (
l
7)
The network indicator (red) keeps blinking.
≥
This unit is not connected to the network.
Check the network connection. (
l
7)
Cannot select this unit as the output
speakers.
≥
Make sure that the devices are connected to
the same network as this unit.
≥
Reconnect the devices to the network.
≥
Turn off and then on the wireless router.
Playback does not start.
The sound is interrupted.
≥
If using the 2.4 GHz band on the wireless
router, simultaneous use with other 2.4 GHz
devices, such as microwaves, cordless
telephones, etc., may result in connection
interruptions. Increase the distance between
this unit and these devices.
– If your wireless router supports 5 GHz band, try using
the 5 GHz band.
To change to the 5 GHz band, perform a network
reset (
l
9), and redo the network settings using an
Internet browser (
l
8). On the step 5, make sure to
select your network name (SSID) for the 5 GHz
band.
≥
Do not place this unit inside a metal cabinet,
for it might block the Wi-Fi signal.
≥
Place this unit closer to the wireless router.
≥
If several wireless devices are
simultaneously using the same network as
this unit, try turning off the other devices or
reducing their network usage.
≥
Reconnect the devices to the network.
≥
Turn off and then on the wireless router.
≥
Try a wired LAN connection. (
l
10)
Slow to switch to network mode.
≥
It may take some time to switch from rear
surround mode to network mode when this
system is connected wirelessly.
Firmware updates
Network
SC-ALL9&6-SQT1211_mst.book 23 ページ 2016年1月12日 火曜日 午後3時16分