Panasonic SA-HT441WP, Service Manual

Page: 33 / 121

Be careful when disassembling and servicing.
Some chassis components may have sharp edges.
Special Note:
10 Assembling and Disassembling
“ATTENTION SERVICER”
1. This section describes the disassembly procedures for all the major printed circuit boards and main components.
2. Before the disassembly process was carried out, do take special note that all safety precautions are to be carried out.
(Ensure that no AC power supply is connected during disassembling.)
3. For assembly after operation checks or replacement, reverse the respective procedures.
Special reassembly procedures are described only when required.
4. The Switch Regulator IC may have high temperature after prolonged use.
Use caution when removing the top cabinet and avoid touching heat sinks located in the unit.
5. Select items from the following index when checks or replacement are required.
· Disassembly of the Top Cabinet
· Disassembly of the Front Panel
· Disassembly of the Tray Assembly
· Disassembly of the Rear Panel
· Disassembly of the Mechanism Base
· Disassembly of the FL & Head Phone P.C.B.
· Disassembly of the XM Module P.C.B.
· Disassembly of the Main P.C.B.
· Disassembly of the AC-Inlet, Power & Sub power P.C.B.
· Disassembly of Digital Amp IC(IC5000)
· Disassembly of Digital Amp IC (IC5400)
· Disassembly of Regulator Diodes and Transistor
· Disassembly of Switch Regulator IC & Diode (IC5701/D5702)
·
Disassembly of the Tray Base Guide (L) and Tray Base Guide (R)
·
Disassembly of the Rotary Tray
·
Disassembly of the Open Lock Gear
·
Disassembly of the Close Lock Gear
·
Disassembly of the Tray Motor P.C.B.and Sensor P.C.B.
· Disassembly of the Traverse Unit
· Disassembly of the Pulley Gear
· Disassembly of the Loading Motor P.C.B.
· Disassembly of the Drive Gear (A) & (B)
· Disassembly of Fixed Plate, Magnet and Clamper
· Disassembly of Cam Gear & Support Piece
· Disassembly of the Slide Plate (L) & (R) and Change Lever
· Assembly of Tray Assembly
33
SA-HT441WP