Panasonic S-LINK V, User Manual

Page: 66 / 182

66
Chapter 3
Starting
Power-on (Main Power and Local Power)
● To use both the main and local power supply units, turn on the local power supply unit first, and
then turn on the main power supply unit, or turn on these power supply units at the same time.
● To turn on the power for the first time after installing the system, be sure to set the mode selector
switch to ‘CONFIG.’
CAUTION
At the completion of check before starting, turn on the power.
The S-LINK V system will be activated.
CONFIG mode
Settings for SL-VCU1 are indicated in this section.
● For a detailed description of the following controllers, refer to their respective user’s manuals.
SL-VGU1-C , SL-VGU1-D : SL-VGU1-C / SL-VGU1-D User’s Manual
SL-VGU1-EC : SL-VGU1-EC User’s Manual
SL-VGU1-485 : SL-VGU1-485 User’s Manual
● For a detailed description of the control module, refer to the ‘ S-LINK V Control Module
Product Specifications .’
● For a detailed description of the handy monitor, refer to the ‘ S-LINK V Handy Monitor In-
struction Manual .’
NOTE
In the CONFIG mode, the displayed items depend on the CONFIG mode selection timing.
● If the system is switched to the CONFIG mode before power-on:
• Each item can be set.
● If the system is switched to the CONFIG mode after power-on:
Difference from the above-described case (CONFIG mode selection before power-on) is the following two
points:
• The default items will not be displayed.
• The set value of each item is displayed, but changing the set value is not possible.
However, the display mode between the decimal number display mode and the hexadecimal number display
mode can be switched. In addition, the system setting function can be activated.