Panasonic : S-26PU1U6, Technical Data & Service Manual

Page: 283 / 297

5-23 5-22
5. Outdoor unit maintenance remote control
2WAY SYSTEM
Outdoor Unit Maintenance Remote Controller
6. Mode Settings
Setting mode 2
<Operating procedure>
Press and hold the
À
Á
(Check) button and
(Ventilation) button simultaneously for 4
seconds or longer.
Press the temperature setting
and
buttons to change the item code. The item codes
and setting data are shown in the table below.
Press the timer time buttons to
change the setting data.
To confirm the changed setting data, press the
button.
(At this time, “ ” display stops blinking
and remains lit.)
During this mode, “ ” is displayed,
blinking. The outdoor unit address display section
displays “ALL,” the item code and number (DN
value in the table), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The
display changes between the first 3 digits (Fig. A )
and the last 3 digits (Fig. B
B
B A
A
).
When the first 3 digits are displayed, the bottom dot
of the colon is illuminated.)
To exit the setting mode, press the (Check)
button.
and are displayed alternately.
(Example shows display of 000 410.)
Display of fi rst 3 digits
Display of last 3 digits
Â
Ã
Ä
and
A
A
r e t e m a r a P e d o c m e t I
80 Refrigerant type 407 = R407C 22 = R22 410 = R410A
81 Outdoor unit capacity* 0 = Disabled
112 : Type 36 80 : Type 26 140 : Type 42
Do not set
Do not set
Do not set
82 Control system schedule
83 Control system schedule
84 3-phase or single-phase 0 = 3-phase 1 = single-phase
85 Power frequency Do not set
86 Control system schedule
List of Item Codes (continued)
(*) Figures represent the capacity data for each model.
Do not set 8E Control system schedule
Do not set 8b Control system schedule
Do not set 8A Control system schedule
0 = No 1 = Yes 89 Crank case heater control
Do not set 88 Control system schedule
Do not set 87 Control system schedule
À
Á
Á
 Ä
À Â Ä
5
SM830203-04.indb 23 15/10/08 13:33:43