Panasonic RX-D500, Operating Instructions Manual

Page: 7 / 14

- 7 -
Listening to FM radio
You can preset up to 30 FM channels.
Channel 1 to 5 will be set under [1] to [5] on this unit.
(
l
right, “Changing the stations stored under [1] to [5]”)
Preparation
≥
Extend the antenna. (
l
4)
≥
Turn the unit on.
≥ Press [FM] to select “FM”.
1
Press [SETUP] to select “A.PRESET”.
2
Press [ : / 6 ] or [ 5 / 9 ] to select “LOWEST” or
“CURRENT” and then press [
1
/
;
].
LOWEST:
To begin auto preset with the lowest frequency
(“FM 87.50”).
CURRENT:
To begin auto preset with the current frequency.
§
≥
The tuner starts to preset all the stations it can receive into
the channels in ascending order.
≥ To cancel, press [ ∫ ].
§
:
To change the frequency, refer to “Manual tuning”.
1
Press [SETUP] repeatedly to select “TUNE MODE”.
2
Press [ : / 6 ] or [ 5 / 9 ] to select “PRESET”
and then press [
1
/
;
].
3
Press [
:
/
6
] or [
5
/
9
] to select the channel.
≥
You can select channel 1 to 5 by pressing one of [1] to [5] on this
unit.
∫
Manual tuning
1
Press [SETUP] repeatedly to select “TUNE MODE”.
2
Press [
:
/
6
] or [
5
/
9
] to select “MANUAL”
and then press [
1
/
;
].
3
Press [ : / 6 ] or [ 5 / 9 ] to tune in to the
station.
To tune automatically, press and hold the button until
the frequency starts changing quickly.
1
While listening to the radio broadcast
Press [
1
/
;
].
2
Press [ : / 6 ] or [ 5 / 9 ] to select the channel
and then press [
1
/
;
].
≥
Do steps 1 through 2 again to preset more stations.
≥ A station previously stored is overwritten when another station is
stored in the same channel preset.
You can change the stations stored under [1] to [5] easily.
While listening to the radio broadcast
Press and hold one of [1] to [5] until “P
 ” appears on the
display.
(“

” stands for a number.)
≥ When you change the stations stored under [1] to [5], channel 1
to 5 are also changed to the same corresponding stations.
∫
To display the current FM signal status
Press [DISPLAY].
≥
“STEREO” is displayed when this unit tunes to a stereo
broadcast.
Presetting stations automatically
Listening to a preset channel
Presetting stations manually
Changing the stations stored under [1]
to [5]
“FM ST”: FM stereo broadcast is being received.
“FM - - - -”: No broadcast is received or FM broadcast
received is weak or in monaural.
“FM MONO”: You have set the “FM MODE” to “MONO”.
( l 11, “If noise is excessive during FM
reception.”)
RX-D500-TQBJ2327_eng.book 7 ページ ２０２１年２月２６日 金曜日 午後５時９分