Panasonic RX-D500, Operating Instructions Manual

Page: 11 / 14

- 11 -
Incorrect display or play does not start.
≥
Make sure that the disc is compatible with this unit. (
l
9)
≥ There is moisture on the lens. Wait for about an hour and then try
again.
If noise is excessive during FM reception.
≥ Change the audio to be output as monaural.
1
Press [SETUP] repeatedly to select “FM MODE”.
2
Press [ : / 6 ] or [ 5 / 9 ] to select “MONO” and then press
[
1
/
;
].
The sound becomes monaural.
≥
To cancel, select “STEREO” or change the frequency.
In normal circumstances, select “STEREO”.
Static or noisy reception is heard while listening to a
radio broadcast.
≥
Check and adjust the antenna.
≥ Try to keep a certain amount of distance between the antenna and AC
mains lead.
≥ Turn the TV or other audio players off or separate it from this unit.
≥
Keep mobile phones away from this unit.
≥ Noise would be heard when batteries are low. Connect the AC mains
lead or replace batteries.
The following messages or service numbers may
appear on the unit’s display.
“--:--”
≥ You plugged the AC mains lead in for the first time or there was a
power failure recently. Set the time (
l
8).
“ADJUST CLOCK”
≥
Clock is not set. Adjust the clock accordingly.
“ADJUST TIMER”
≥ Play timer is not set. Adjust the play timer accordingly.
“AUTO OFF”
≥ The unit has been left unused for about 20 minutes and will shut down
within a minute. Press any button to cancel it.
“ERROR”
≥
Incorrect operation is performed. Read the instructions and try again.
“F  ” / “F  ” (“  ” stands for a number.)
≥ There is a problem with this unit.
Disconnect the AC mains lead from the mains socket, reconnect it to
the outlet after about 30 seconds. Wait for about 10 seconds, then turn
on the unit. If the problem still persists, disconnect the AC mains lead
and consult your dealer.
“NO DISC”
≥ Insert the disc to be played ( l 5).
“NO PLAY”
≥ Examine the content. You can only play supported format. ( l 12)
≥
The unit may have a problem. Turn the unit off and then on again.
“PLAY ERROR”
≥ You played an unsupported file. The system will skip that track and
play the next one.
“READING”
≥
The unit is checking the “CD” information. After this display has
disappeared, start operating.
“USB OVER CURRENT ERROR”
≥ The USB device is drawing too much power. Disconnect the USB
device, turn the unit off and then on again.
≥ Check the connection, it may be caused by a faulty USB cable.
“VBR”
≥
The system cannot show the remaining play time for variable bit rate
(VBR) tracks.
“WAIT”
≥ This is displayed, for example, when this unit is turning off.
Disc
Radio
Messages
RX-D500-TQBJ2327_eng.book 11 ページ ２０２１年２月２６日 金曜日 午後５時９分