Panasonic Road Choice 1000-RIO160U, Operating Instructions Manual

Page: 15 / 16

Audio Settings
1
Press [VOL] (PUSH SEL) to open the audio menu.
Note: If no operation takes place for more than 5 seconds in audio setting (2 seconds in the volume adjustment), the dis -
play returns to the regular mode.
2
Press [VOL] (PUSH SEL) to select a mode to be
adjusted.
3
Turn [VOL] clockwise ( q ) or counterclockwise ( w )
to adjust.
Volume
(Setting Range: 0 to 40, Default: 18) q / w : Adjustment
Bass
(Setting Range: −12 dB to +12 dB by 2 dB, Default: 0 dB) q / w : Adjustment
Treble
(Setting Range: −12 dB to +12 dB by 2 dB, Default: 0 dB) q / w : Adjustment
Balance
(Setting Range: 15 levels each, Default: CNT (center)) q / w : Adjustment
Fader
(Setting Range: 15 levels each, Default: CNT (center)) q / w : Adjustment
Notes:
¡ The volume can also be adjusted directly using [VOL] on the main unit. ( a “General”)
¡ Do not activate SQ and Bass/Treble at the same time to avoid causing sound distortion.
¡ If the fader is set to front, the pre-amp. output (rear) is decreased.
[VOL]
selects a value in the audio menu.
(PUSH SEL : Select)
selects items in the audio menu.
Troubleshooting
If You Suspect Something Wrong
Check and take steps as described below.
If the described suggestions do not solve the problem, it is
recommended to take the unit to your nearest authorized
Panasonic Service Center. The product should be serviced
only by qualified personnel. Please refer the checking and
the repair to professionals.
Panasonic shall not be liable for any accidents arising out
of neglect of checking the unit or your own repair after
your checking.
Warning
¡ Do not use the unit in an irregular condition, for ex -
ample, without sound, or with smoke or a foul smell,
which can cause ignition or electric shock. Immedi -
ately stop using the unit and consult your dealer.
¡ Never try to repair the unit by yourself because it is
dangerous to do so.
Trouble Possible Solution
Common
No power ¡ Start the engine. (Alternatively, turn the igni -
tion switch to the ACC position.)
¡ Verify the wiring. (Battery lead, power lead,
ground lead, etc.)
¡ Fuse blown (Consult your dealer or an autho -
rized Panasonic Service Center.)
¡ Ask a professional for fuse replacement.
¡ Be sure to use the same rated fuse.
No sound ¡ Disable the mute function.
¡ Verify the wiring.
¡ Wait until the dew disappears before turning
on the unit.
Noise
¡ Make sure that grounding is established
properly.
No sound from
left, right, front,
or rear speaker
¡ Adjust the balance and fader.
¡ Verify the wiring.
Left and right
sounds are
reversed
¡ Connect the speaker lead correctly.
Disc Player
No sound, or
disc is automati-
cally ejected
¡ Load the disc correctly.
¡ Clean the disc.
Sound skip, poor
sound quality
¡ Clean the disc.
Sound skip due
to vibration
¡ The maximum permissible tilt angle is 30°.
¡ Secure the unit.
Disc not eject-
able
¡ Press [ u ] . If the disc is still not ejected, con -
sult your dealer or an authorized Panasonic
Service Center.
Radio
Frequent noise ¡ Tune in to another station of high-intensity
waves.
¡ Make sure that the antenna mounted point
is grounded properly.
Preset data
deleted
¡ The preset memory is cleared to return to
the original factory setting when the power
connector or battery is disconnected.
Error Display Messages
Display/Trouble Possible Solution
Radio
No operation by some cause.
¡ Switch the power or ACC
ON/OFF. If this does not
solve the problem or the
unit is still out of order,
consult your dealer or
an authorized Panasonic
Service Center to ask for
repairs.
Disc Player
(The disc is ejected automatically.)
The disc is dirty or upside down.
¡ Check the disc.
(The disc is ejected automatically.)
The disc has scratches.
¡ Check the disc.
No operation by some cause
¡ If normal operation is not
restored, consult your
dealer or an authorized
Panasonic Service
Center to ask for repairs.
Cannot read the file
¡ Check the disc.
Never take measures especially those other than indicated by italic letters in “Possible Solution” described below
because those are too dangerous for users to handle themselves.