32
For Windows CE:
The diagram below shows an example screen of Personal Digital Assistant (PDA).
However, different screens may be found depending on manufacturers and models:
typical settings when the projector is just shipped from the factory or when Simple
Connection is turned ON.
(1) On a PDA, go to [Settings]
→
[Connect To]
→
[Network adaptor], then select
[Gemtek Wireless LAN PC Card] and click [Properties].
(2) Check [Use specified IP address] and set the address of the same group as the
projector.
(3) Set IP address to [192.168.10.20] and set subnet mask to [255.255.255.0] and
click [OK].
(4) If the projector uses WEP (encryption ), go to [Start]
→
[Settings]
→
[System]
→
[Wireless Settings] and select [Encryption].
(5) Change Encryption (WEP) from “Disabled” to 64 bits or 128 bits. Checkmark
“Create Keys Manually”, enter the same WEP key as the projector in
hexadecimal (0-9, A-F) into Key 1 and click [Apply].
To enter WEP settings of the projector with characters, use hexadecimals with
reference to the ASCII code table on the next page.
Network setting
